E asy fun fold card using the Sailing Home stamp set and coordinating Smooth Sailing Dies, High Seas Embossing Folder, and Come Sail Away Designer Series Paper!
Project Recipe
Cardstock measurements (in inches):
1. Pool Party: 2 pieces cut at 4-1/4 x 11 and scored at 2-3/4 and 5-1/2.
2. Night of Navy: 4 x 5-1/4
3. Whisper White: 3-7/8 x 5-1/8 (card front)
4. Whisper White: 4 x 5-1/4 (inside of card)
5. Night of Navy: 2-1/2 x 4 (right panel)
6. Designer Series Paper: 2-1/4x 3-3/4 (right panel)
7. Crumb Cake: 1/2 x 3 (for greeting banner)
8. Crumb Cake: 3/8 x 3-3/4
9. Pool Party: 3/8 x 4
10. Night of Navy: 3/8 x 4-1/2
11. Soft Suede scrap for wheel
12. Whisper White scrap for lighthouse
13. Night of Navy for oval
Fold Pool Party card base pieces on score lines. Put adhesive on the back of one of the card base panels (the panel that measures 5-1/2 x 4-1/4), and adhere the two together so that the folded panels are on the opposite ends.
Adhere the inside whisper white piece to the inside of the card.
Put adhesive on the left side of the Night of Navy layer and adhere to the left side of the card on the folded panel.
Adhere the smaller piece of Night of Navy cardstock to the right folded panel, then adhere the designer series paper to the navy layer.
Run the 3-7/8 x 5-1/8 piece of Whisper White through a die cutting machine using the High Seas 3D embossing folder.
Adhere to the Night of Navy layer (left panel).
Create banners out of the small strips of cardstock, and adhere them to the card front as shown.
Ink up your greeting in Night of Navy ink and stamp on the wider Crumb Cake strip, and adhere as shown.
Using your die cutting machine, cut out the following...
**the wheel from the Smooth Sailing Dies
**the largest oval from the Stitched Shapes Dies
**Ink up the lighthouse image from the Sailing Home stamp set in Night of Navy ink and cut out using the lighthouse die from the Smooth Sailing Dies.
Adhere the stitched oval to the card front as shown using Stampin' Dimensionals.
Adhere the lighthouse to the oval using Stampin' Dimensionals.
Adhere the wheel using a mini glue dot.
Tie a bow out of Night of Navy/Sahara Sand baker's Twine and adhere to the center of the wheel with a Mini Glue Dot.
The finished card fully opened.