Project Recipe
Create a C6 card base from a piece of Sahara Sand cardstock. (Cut in half lengthwise at 14,9cm and the score at 10.5cm)
Use the spotted image from the Petal palette stamp set and sahara sand ink to stamp a tone on tone band across the card, just below the centre.
Stick a 5cm wide strip of Wood Textures Designer Series Paper down the length of the card base, approx. 1.5cm in from the left edge.
On a piece of shimmer white card, stamp the rose image with Stayzon ink and colour it with watercolour pencils and a blender pen. Die cut the image using the coordinating "Petals and More" thinlits. Also using the thinlits, cut the trellis border from copper foil; some foliage from old olive card and the sentiment banner from old olive and sahara sand cardstock.
On a piece of shimmer white card, stamp the rose image with Stayzon ink and colour it with watercolour pencils and a blender pen. Die cut the image using the coordinating "Petals and More" thinlits. Also using the thinlits, cut the trellis border from copper foil; some foliage from old olive card and the sentiment banner from old olive and sahara sand cardstock.
Stamp the sentiment on the sahara sand banner using old olive ink. Cut the olive banner in half lengthways and adhere to the back of the stamped banner. Stick this to the card at the bottom right.
Stick the copper trellis across the spotted stamped band on the card base. Trim the foliage to the required length and then stick that to the card. Add the roses, raising them up on dimensionals. Add a couple of spots of Fine tip glue to the roses to create waterdrops. You will need to place you card somewhere it won't be knocked so these can dry. Finish the card with an epoxy heart in the top right.