Project Recipe
Take a piece of Just Jade card stock measuring 14.9cm x 21cm and score at 10.5cm on the long side. Fold to create a card base.
Cut a curvy border diagonally across a 10cm x 9.5cm piece of Pool Party card stock. Place a piece of white card stock across the back and trim to match the curved edge.
Stamp the greeting onto a 2.5cm x 7cm piece of Just Jade card stock. Use the Label Me Fancy punch to punch a slot each end. Thread some Pool Party ribbon through the slots. Stick the label to the front of the Pool Party card and then wrap the ends of the ribbon around the back of the card and tape in place. Use another small piece of ribbon to tie a knot on the left hand side.
Stick a piece of Designer Series Paper measuring 9.5cm x 8.5cm to the top of the card, positioning it so you have an equal border at the top and two sides. Stick the Pool Party card to the bottom of the card front, again leaving equal borders on the 3 sides.
Take all the die cut blossoms and stick them to the Pool Party card, ensuring some are peeping out from underneath the label.
Add a 13.9cm x 9.5cm white mat to the inside of the card.