C reate a fun card using the Trucking Along bundle. Note - this card uses retired Designer Series Paper.
Project Recipe
Measurements:
Cherry Cobbler Base
- 11" x 4 1/4", score @ 5 1/2"
DSP
- 3" x 5 1/2"
Shaded Spruce Leaves
- 8 1/2" x 1 1/2" - Punch 4
Gold Foil Sprigs -
- 1" strip - enough to punch 2
Basic White -
- 1 1/4" wide and long enough to
punch 1 Truck
- 2 1/4" x 2 3/4" - die cut square
- 4" x 5 1/4" - inside layer
Card Assembly:
Fold and burnish the Cherry Cobbler card base.
Attach the DSP to the center of the card front. This is cut so that it goes edge to edge on the 5 1/2" side.
Die cut the Basic White cardstock using the square die from the Nested Essentials. Then stamp the sentiment at the top of the square using Memento Black ink.
Using the Shaded Spruce strip of paper, Punch 4 sets of leaves using the Bough Punch.
Using the Gold Foil strip, punch 2 smaller sprigs.
Using the 1 1/4" strip of Basic White, stamp the truck image using Memento Black ink.
Punch the truck and color using Stampin' Blends. I used Cherry Cobbler, Smoky Slate, and Basic Black for this card. You can make the truck any color you wish. However, alcohol markers are recommended.
Take the stamped square and apply double-sided tape to the back on 2 opposite corners.
Attach 2 Shaded Spruce leaves and 1 gold sprig to each corner.
Apply dimensionals to the back of the Basic White square and attach it to the card front.
Apply dimensionals to the back of the truck and attach it to the white square just under the sentiment.
Tie a bow and attach it to either corner of the Basic White square using a glue dot.
Stamp the sentiment on the Basic White card layer along with any other images you want. Attach to the inside of the card.
You are finished!