P retty thank you card using Stampin' Up! products.
Project Recipe
Cut cardstock pieces to the following sizes using a Paper Trimmer:
- card from Soft Sea Foam Cardstock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 3-1/2" x 4-3/4" from Azure Afternoon Cardstock
- 3-3/8" x 4-5/8" from Soft Sea Foam Cardstock
- 2" x 2-1/2" from Basic White Cardstock
- 1/2" x 3-1/4" from Basic White Cardstock
Insert the Soft Sea Foam rectangle into the floral embossing folder included in the Basics 3D Embossing Folders. Use the line printed on the front flap of the folder to make sure it is lined up straight. Place the folder with the cardstock inside on the platform on your Stampin' Cut & Emboss Machine and run through the machine.
Adhere the dry embossed rectangle to the center of the Azure Afternoon rectangle and then to the front of the Soft Sea Foam card in the center.
Unlock the Happy Labels Pick A Punch. Slide one short edge of the thin white strip into the right side of the punch (the side of the punch with the smaller scallops) as far as it will go and get it centered. Punch.
Mount the "you're the best" sentiment from the Translucent Florals Set on Block G. Ink it up with the Azure Afternoon Ink Pad. Stamp it in the center of the punched white strip so it is closer to the punched edge with the punched edge on the left.
Put a strip of Tear & Tape Adhesive along the long bottom edge of the back of the stamped sentiment strip. Remove the protective backing.
Use the Azure Afternoon ribbon from the 3/8" Sheer Ribbon Combo Pack. Leave the ribbon on the roll and slowly and carefully adhere it to the Tear & Tape on the bottom of the sentiment strip pleating it as you go and making sure some of the ribbon will show along the bottom edge of the sentiment strip. Trim off the ribbon when you get to the end of the sentiment strip. Put another strip of Tear & Tape Adhesive across the top of the pleated ribbon to help hold it in place.
Remove the protective backing from the second strip of Tear & Tape Adhesive and adhere the sentiment strip with pleated ribbon attached to the front of the card so it is about 5/8" from the left edge of the card and about 1-1/4" from the bottom edge of the card.
Mount the large, full flower image from the Translucent Florals Set on Block D. Ink it up with the Azure Afternoon Ink Pad. Stamp it in the center of the white rectangle.
Pick out the matching, open flower die from the Translucent Florals Dies. Put it on top of the stamped flower on a platform on your Stampin' Cut & Emboss Machine so it is centered over the flower. Run through the machine.
Use Stampin' Dimensionals to adhere the flower cut out to the front of the card so it overlaps the right end of sentiment strip as shown at a slight angle.
Use the mini spatula on the Take Your Pick to carefully peel up 1 large blue sequin from the sheet of Adhesive-Backed Glitter Sequins making sure that you get the adhesive backing as well. Adhere it to the center of the flower cut out as shown.
Use the mini spatula on the Take Your Pick to carefully peel up 2 dragonflies from the sheet of Adhesive-Backed Dragonflies & Birds making sure that you get the adhesive backings as well. Adhere them to the front of the card as shown.