D ecorated Acetate Card Box filled with Halloween treats using Stampin' Up! products.
Cut cardstock, Glimmer Paper, and designer paper pieces to the following sizes using a Paper Trimmer and Paper Snips:
- 4-1/4" x 5-5/8" from Sahara Sand Cardstock
- 4-1/8" x 5-1/2" of floor plan design from Monster Bash Designer Series Paper
- 2-1/4" x 3-1/4" from Gold Glimmer Paper
- 1" x 2-1/4" from Crushed Curry Cardstock
- large haunted house cut from sheet of haunted houses design from Monster Bash Designer Series Paper
Fold an Acetate Card Box together, fill it with treats, and close the box.
Adhere the large rectangle of floor plan Monster Bash Designer Paper to the Sahara Sand rectangle.
Use Tear & Tape Adhesive strips to adhere the matted designer paper to the top of the card box.
Unlock the 2" Circle Punch. Slide the strip of Glimmer Paper into the punch. Punch.
Use Tear & Tape Adhesive to adhere the Glimmer Paper circle punch out to the front of the box so it is about 3/4" from the left and 1" from the bottom.
If you haven't already done so, cut out a large haunted house from the haunted houses design of Monster Bash Designer Paper using Paper Snips.
Use Tear & Tape Adhesive to adhere the haunted house cut out to the center of the Glimmer Paper circle punch out.
Cut an 18" piece of Basic Black 3/8" Scalloped Edge Ribbon.
Wrap the ribbon around the bottom of the box so it covers the bottoms of the haunted house cut out. Tie in place with a knot. Trim the ends.
Mount the "Spooky" or "Creepy" sentiment from the Spooktacular Bash Set on Block B. Ink it up with the Memento Pad. Stamp it in the center of the Crushed Curry strip.
Pick out the small stitched label die with rounded ends from the Ornate Frames Dies. Put it on top of the stamped sentiment on a platform on your cutting and embossing tool so the sentiment is more to the right. Run through the tool.
Use Black Stampin' Dimensionals to adhere the sentiment cut out to the front of the box so it is centered over the ribbon just to the right of the knot on the right side of the haunted house cut out.
Use the mini spatula on the Take Your Pick tool to pick up a large gray circle shape and two small gray circle shapes from a sheet of Monster Bash Enamel Shapes being sure to get the adhesives as well. Adhere them to the front of the box in the upper right corner.