P layful card using Stampin' Up! products.
Project Recipe
Cut cardstock and designer paper pieces to the following sizes using a cutting and scoring tool:
- card from Coastal Cabana Cardstock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" from Whisper White Cardstock
- 3-3/8" x 3-7/8" from Coastal Cabana Cardstock
- 3-1/4" x 3-3/4" of mottled Coastal Cabana design from Follow Your Art Designer Series Paper
- 2-1/4" x 2-3/4" from Whisper White Cardstock
- 1" x 1-1/2" from Whisper White Cardstock
Mount the "You're So Cool" sentiment from the Playful Penguins Set on Block G. Ink it up with the Coastal Cabana Ink Pad. Stamp it in the lower right corner of the large Whisper White rectangle so it is about 1/4" from the bottom and 5/8" from the right side.
Adhere the stamped white rectangle to the front of the Coastal Cabana card.
Drag the open VersaMark Pad across the piece of Follow Your Art Designer Series Paper a few times.
Place the inked up designer paper rectangle in the center of a piece of Grid Paper. Sprinkle on Shimmer White Stampin’ Emboss Powder so it covers the whole rectangle. Tap off excess powder. Use a small paintbrush to brush off more of the powder, leaving it streaky all over the designer paper. Return extra powder to the container.
Heat with the Heat Tool until the powder is completely melted (shiny).
Adhere the heat embossed designer paper rectangle to the center of the Coastal Cabana rectangle.
Cut a 3-3/4" piece of Bermuda Bay 1/4" Mini Striped Ribbon.
Lay the ribbon across the bottom of the matted designer paper piece so it is about 3/8" from the bottom. Secure in place on the back with strips of Tear & Tape Adhesive.
Remove the protective backings from the Tear & Tape pieces and add SNAIL to the back of the Coastal Cabana rectangle. Adhere the rectangle to the front of the card so it is about 7/16" from the top, left, and right edges.
Mount the penguin looking to the right image from the Playful Penguins Set on Block D. Ink it up with the Basic Gray Ink Pad. Stamp it on the medium white rectangle.
Cut out the penguin by hand using Paper Snips.
Mount the scarf image from the Playful Penguins Set on Block B. Ink it up with the Coastal Cabana Ink Pad. Stamp it on the remaining small white rectangle.
Cut out the scarf by hand using Paper Snips. Adhere the scarf to the penguin's neck.
Use Stampin' Dimensionals to adhere the penguin to the front of the card so the left wing hangs over the left side of the matted designer paper a bit and the feet overlap the ribbon a bit.
Use the mini spatula on the Take Your Pick tool to pick up a large frosted droplet from a sheet of Frosted & Clear Epoxy Droplets being sure to get the adhesive as well. Adhere it to the upper right corner of the matted designer paper.
Cut a 3" piece of Bermuda Bay 1/4" Mini Striped Ribbon.
Slide one end of the small piece of ribbon under the ribbon already on the card front near the right side. Tie in place using a half knot. Trim the ends.