P retty thank you card using Stampin' Up! products.
Project Recipe
Cut cardstock pieces to the following sizes using a Paper Trimmer:
- card from Bumblebee Cardstock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" from Mossy Meadow Cardstock
- 3-7/8" x 5-1/8" from Very Vanilla Cardstock
- 1-1/2" x 1-3/4" from Mossy Meadow Cardstock
- 1-1/2" x 1-3/4" from Very Vanilla Cardstock
Insert the large Very Vanilla rectangle into the Magnolia 3D Embossing Folder so the flowers are at the top of the cardstock. Place the folder with the cardstock inside on a platform on your Stampin' Cut & Emboss Machine and run through the machine.
Adhere the dry embossed vanilla cardstock to the center of the large Mossy Meadow rectangle.
Cut a 4-1/2" piece of the Bumblebee 1/4" Gingham Ribbon.
Lay the ribbon across the layered, dry embossed vanilla and Mossy Meadow rectangle so it is about 7/8" from the bottom. Flip the cardstock layers over and fold the ends of the ribbon over. Adhere the ends of the ribbon in place with pieces of Tear & Tape Adhesive.
Remove the protective backing from the Tear & Tape strips and add Stampin' Seal to the back of the Mossy Meadow rectangle. Adhere it to the front of the Bumblebee card.
Mount the large Many Messages stamp on Block F. Ink up the right portion of the stamp near the bottom with the "Thank You Ever So Much" sentiment in a rectangle using the Mossy Meadow Ink Pad. Stamp the sentiment in the center of the small vanilla rectangle.
Put the Messages Die on top of the stamped sentiment square on a platform on your Stampin' Cut & Emboss Machine so the lightly scalloped rectangle on the bottom right side of the die is centered over the sentiment. Run through the machine. Keep the die out.
Place the Messages Die on top of the small Mossy Meadow rectangle on a platform on your Stampin' Cut & Emboss Machine so the lightly scalloped, rounded edge rectangle near the center of the die is centered over cardstock. Run through the machine.
Adhere the sentiment rectangle cut out to the center of the Mossy Meadow rectangle cut out.
Use Stampin' Dimensionals to adhere the matted sentiment rectangle cut outs to the front of the card so they are centered over the ribbon on the right side.
Pick out two bugs from the Ladybug Trinkets. Use Mini Glue Dots to adhere the ladybugs in place on the card front as shown.
Cut a 3" piece of the Bumblebee 1/4" Gingham Ribbon.
Slide one end of the ribbon under the ribbon already on the card front just to the left of the matted sentiment rectangle cut outs. Tie in place with a half knot. Trim the ends.