N o stamping birthday card using Stampin' Up! products.
Project Recipe
Cut cardstock and designer paper pieces to the following sizes using a Stampin' Trimmer:
- card from Pool Party Cardstock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" from Emerald Envy Cardstock
- 3-7/8" x 5-1/8" from Whisper White Cardstock
- 1-1/4" x 5-1/8" of multicolored gems design from Naturally Eclectic Designer Series Paper
- 3-1/4" x 3-1/2" from Emerald Envy Cardstock
- 3-1/2" square from Pool Party Cardstock
Adhere the strip of Naturally Eclectic Designer Series Paper to the bottom of the white rectangle.
Adhere the white rectangle to the Emerald Envy rectangle.
Cut a 6" piece of Pool Party 3/8" Shimmer Ribbon.
Lay the ribbon piece across the matted white/designer paper layer so it covers the seam between the cardstock and designer paper pieces. Flip the layer over and fold the ends of the ribbon over. Adhere the ends of the ribbon in place with pieces of Tear & Tape Adhesive.
Remove the protective backing from the Tear & Tape strips and add more SNAIL to the back of the cardstock. Adhere the layer to the front of the Pool Party card.
Pick out the scalloped circle framelit that cuts out a scalloped circle that is 3-1/8" diameter from the Layering Circles Framelits. Place the Pool Party square on the Cutting Pad on top of the Platform on the Big Shot. Place the scalloped circle framelit on top. Place another Cutting Pad on top and run through the Big Shot.
Place the Emerald Envy rectangle on the Precision Base Plate on top of the Platform on the Big Shot. Place the Happy Birthday Thinlit on top. Place a Cutting Pad on top and run through the Big Shot a couple of times. Use the Die Brush to remove the pieces from the die.
Place the happy birthday cut out upside down on one side of a Silicone Craft Sheet. Cut a Stamping Sponge into quarters and clamp the triangle edge of one quarter in a large binder clip. Squeeze a small amount of Multipurpose Liquid Glue on one corner of the Silicone Craft Sheet. Dab the sponge into the glue and then lightly onto the back of the happy birthday cut out. Flip the happy birthday cut out over and adhere it to the Pool Party scalloped circle.
Adhere the scalloped circle to the front of the card so it is centered using Stampin' Dimensionals.
Cut a 4" piece of Pool Party 3/8" Shimmer Ribbon. Tie it in a half knot. Trim the ends. Adhere the ribbon to the right side of the scalloped circle using a Mini Glue Dot.