F un and easy card using Stampin' Up! products.
Project Recipe
Cut card stock and designer paper pieces to the following sizes using a Stampin' Trimmer:
- card from Peekaboo Peach Card Stock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" from Emerald Envy Card Stock
- 3-3/4" x 5" of multi-colored splatters on black background design of paper from Playful Palette Designer Series Paper Stack
- 2-1/2" x 2-1/2" of multi-colored stripes on vanilla background design of paper from Playful Palette Designer Series Paper Stack
- scraps of Playful Palette Designer Series Paper Stack with pink, purple, and orange swooshes
Adhere the large rectangle of designer paper to the Emerald Envy layer. Then, adhere it to the front of the Peekaboo Peach card.
Cut a 4-1/2" piece of Emerald Envy 3/8" Ruched Ribbon with angled ends. Put a small strip of SNAIL Adhesive horizontally right in the middle of the designer paper. Adhere the ribbon to it horizontally.
Mount the women's t-shirt outline image from the Custom Tee Photopolymer Set on Block C. Ink it up with the Basic Black Archival Ink Pad. Stamp it on the striped piece of designer paper so the stripes are horizontal.
Mount smaller sentiment of your choice from the Custom Tee Photopolymer Set on Block A. Ink it up with the Basic Black Archival Ink Pad. Stamp it in the center of the shirt across the chest.
Pick out the women's t-shirt framelit from the T-shirt Builder Framelits Dies. Place the stamped designer paper on the Cutting Pad on top of your Magnetic Platform on your Big Shot. Place the t-shirt framelit on top of the stamped shirt image. Place the other Cutting Pad on top and run through the Big Shot.
Adhere the t-shirt cut out to the center of the front of the card using Stampin' Dimensionals.
Mount the single flower image from the Custom Tee Photopolymer Set on Block A. Ink it up with the Sweet Sugarplum Ink Pad. Stamp it on a scrap of designer paper so you get multiple colors in the flower. Repeat two more times being sure to re-ink each time.
Cut out the flowers by hand using Paper Snips.
Put a tiny drop of Fine-Tip Glue Pen on the back of each flower and adhere them to the lower right side of the t-shirt image so they overlap a bit.
Place a medium sized Pearl Basic Jewel in the center of each flower.