P retty Valentine card using Stampin' Up! products.
Project Recipe
Cut cardstock and designer paper pieces to the following sizes using a Paper Trimmer:
- card from Flirty Flamingo Cardstock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" from Real Red Cardstock
- 3-3/4" x 5" of pink swirl design from Most Adored 12" x 12" Specialty Designer Series Paper
- 2" square from Basic White Cardstock
Put the Most Adored Designer Paper rectangle inside the embossing folder included with the Adoring Hearts Hybrid Embossing Folder so it is centered over two vertical rows of hearts. Place the embossing folder with the designer paper inside on a platform on your Stampin' Cut & Emboss Machine. Run through the machine.
Adhere the dry embossed designer paper to the center of the Real Red rectangle and then to the front of the Flirty Flamingo card.
As you are ready to stamp using the Bee My Valentine Set, place the cardstock on the Stampin' Pierce Mat. Using the mat will help you get a cleaner image each time you stamp.
Mount the "love you" sentiment from the Bee My Valentine Set on Block A. Ink it up with the Real Red Ink Pad. Stamp it in the center of the small white square.
Pick out one of the open heart dies from the dies included with the Adoring Hearts Hybrid Embossing Folder. Put it on top of the stamped sentiment on a platform on your Stampin' Cut & Emboss Machine so it is centered over the sentiment. Run through the machine.
Use the side of the brush tip of the Flirty Flamingo Marker to carefully outline the edges of the heart cut out.
Use Stampin' Dimensionals to adhere the heart cut out over the top of the center right embossed heart on the designer paper on the card front as shown.
Cut a 3-1/2" piece of the Real Red ribbon included in the Real Red & Burlap Ribbon Combo Pack.
Tie a half knot in the center of the ribbon. Trim the ends.
Use a Mini Glue Dot to adhere the ribbon knot at an angle as shown on the lower left side of the heart cut out.