M asculine card using Stampin' Up! products.
Project Recipe
Cut cardstock, designer paper, and Foil Sheets pieces to the following sizes using a Paper Trimmer:
- card from Cinnamon Cider Cardstock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" from Very Vanilla Cardstock
- 3" x 5-1/8" of mottled light brown and white map with copper accents design from World Of Good Specialty Designer Series Paper, cut so the words are horizontal on the vertical rectangle
- 1" x 5-1/8" of small copper globes in lines on dark brown background design from from World Of Good Specialty Designer Series Paper
- 1/2" x 4-5/8" from Copper Foil Sheets
- 2-1/2" square from Cinnamon Cider Cardstock
- 1" x 4" from Very Vanilla Cardstock
Adhere the brown map with copper accents World Of Good Specialty Designer Paper rectangle to the large vanilla rectangle so there is about 1/16" inch of vanilla showing on the top, right, and bottom edges.
Adhere the copper globes on brown World Of Good Specialty Designer Paper rectangle to the large vanilla rectangle so there is about 1/16" inch of vanilla showing on the top, left, and bottom edges. It will overlap the left edge of the map designer paper a bit. Make sure the globes are right side up!
Adhere the vanilla/designer paper rectangle to the front of the Cinnamon Cider card.
Use Tear & Tape Adhesive to adhere the Copper Foil Sheets strip to the front of the card so it is centered over the line between the two different pieces of designer paper.
Mount the globe image of your choice from the Beautiful World Set on Block D. Ink it up with the Cinnamon Cider Ink Pad. Stamp onto Grid Paper. WITHOUT RE-INKING, stamp it in the center of the Cinnamon Cider square.
Mount the "you make the world a better place" sentiment from the Beautiful World Set on Block C. Ink it up with the Early Espresso Ink Pad. Stamp it over the center of the previously stamped globe image.
Pick out the open circle die from the World Map Dies. Put it on top of the sentiment stamped globe image square on a platform on your Stampin' Cut & Emboss Machine. Run through the machine.
Adhere the globe circle cut out to the front of the card near the bottom edge so the left edge overlaps the Copper Foil Sheet strip and the right edge of the copper globes on brown strip a bit.
Mount the quill pen image from the Beautiful World Set on Block C at an angle so it fits. Ink it up with the Night Of Navy Ink Pad. Stamp on one end of the 1" x 4" vanilla strip.
Mount the inkwell image from the Beautiful World Set on Block A. Ink it up with the Early Espresso Ink Pad. Stamp the inkwell image on the other end of the 1" x 4" vanilla strip. Make sure to leave room between the images so they can be cut out with the dies.
Pick out the quill pen die and the inkwell die from the World Map Dies. Put them on top of the stamped images on a platform on your Stampin' Cut & Emboss Machine so the images are centered. Make sure the dies do NOT overlap. Run through the machinel.
Adhere the quill pen cut out to the front of the card so it is sticking up on the right side of the sentiment globe circle cut out with the bottom of the quill near the bottom of the circle.
Use a Mini Stampin' Dimensional to adhere the inkwell cut out to the front of the card so it overlaps the bottom of the quill pen.
Cut a 3-1/2" piece of the Early Espresso 1/4" Faux Suede Trim.
Tie a half knot in the center of the trim. Trim the ends.
Use a Mini Glue Dot to adhere the trim knot to the front of the card at an angle on the bottom left side of the sentiment globe circle cut out.