Project Recipe
Cut cardstock pieces to the following sizes:
- Night Of Navy Cardstock: Cut 1 @ 5 1/2" x 8 1/2", scored at 4 1/4".
- Basic White Cardstock: cut 1 @ 4" x 5 1/4", cut 1 @ 3 3/4" x 3 3/4"; cut 1 @ 1/2" x 3 1/2".
- Penguin Playmates Designer Series Paper: cut 1 @ 4" x 5 1/2"; cut 1 Polar Bear with Night Of Navy scarf.
- Be Dazzling Designer Series Paper: scrap for Stars.
Pick out the large rectangle with a notch on one side and a tiny hole in the centre of the die from the Give It A Whirl Dies. Put it on top of the Penguin Playmates DSP rectangle piece and run it through the Stampin' Cut & Emboss Machine.
Pick out the large, scalloped edge circle with a tiny hole in the centre from the Give It a Whirl Dies. Put it on top of the large Basic White square. Run through the Stampin' Cut & Emboss Machine.
Pick out a large, square brad of either color from the Round & Square Brads.
Lay the Penguin Playmates DSP rectangle cut out on top of the white scalloped circle cut out so the holes line up. Insert the prongs of the brad through the holes and flatten them on the back side of the rectangle/circle cut outs.
Put Stampin' Dimensionals all over the back of the layered rectangle cut out making sure that none are too close to the scalloped circle cut out. Remove the protective backings and put another Stampin' Dimensional on top of each dimensional already in place. Remove the protective backings and adhere the layered rectangle/circle cut outs to the front of the Night Of Navy card. Give the spinner wheel a turn to make sure it spins smoothly.
With your Paper Snips fussy cut the Penguin Playmates DSP Polar Bear.
Put a Stampin' Dimensional on the brad. Place the Bear on the brad making sure that he spins freely.
Pick out one of the sets of three small stars dies from the Give It A Whirl Dies. Put it on top of the Be Dazzling DSP. Run through the Stampin' Cut & Emboss Machine.
Use a Mini Glue Dot to adhere the medium & large star cut outs to the front of the card Penguin Playmates DSP rectangle cut out.
Using the Lovely Label Pick A Punch punch each end of the Basic White Cardstock greeting piece.
Mount the greeting from Snowman Season Stamp Set. Stamp greeting on punched piece of Basic White Cardstock using Night Of Navy Classic Ink Pad.
Adhere the greeting to the card front with Stampin' Dimensionals. Use a Mini Glue Dot to adhere the smallest star to the greeting.
Mount the sentiment from the Snowman Season Stamp set.
Use Night Of Navy Classic Stamp Pad to ink up the sentiment. Stamp on the Basic White Cardstock. Adhere the sentiment piece to the inside of the card with Stampin' Seal or Multipurpose Liquid Glue.