F un, new home card using Stampin' Up! products.
Project Recipe
Cut cardstock and designer paper pieces to the following sizes using a cutting and scoring tool:
- card from Crushed Curry Cardstock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 3-3/4" x 5-1/2" of floor plan design from Monster Bash Designer Series Paper
- 2-1/2" x 3-1/4" from Basic Gray Cardstock
- 2-1/2" x 3-1/4" from Crushed Curry Cardstock
Adhere the piece of Monster Bash Designer Series Paper to the front of the Crushed Curry card so it is centered down the middle.
Mount the "may your troubles be less..." sentiment from the Barn Door Set on Block C. Ink it up with the Basic Gray Ink Pad. Stamp it in the center of one end of the Crushed Curry strip (leave room to punch it out).
Unlock the 2" Circle Punch. Hold it upside down so you can see the punching area. Slide the stamped sentiment into the punch and get it centered in the punching area. Punch.
Unlock the 2-1/4" Circle Punch. Slide the Basic Gray strip into the punch and punch.
Adhere the sentiment circle to the center of the Basic Gray circle.
Adhere the matted circles to the front of the card so the edge of the gray circle just overlaps the edge of the designer paper on the lower left side.
Cut a 3-1/2" piece of the Crushed Curry 3/8" Crinkled Seam Binding Ribbon.
Tie a half knot in the center of the ribbon. Trim the ends.
Use a Mini Glue Dot to adhere the ribbon knot at an angle to the lower right side of the matted circles.
Use the mini spatula on the Take Your Pick to carefully peel up two small and one large Basic Gray circles from the sheet of Monster Bash Enamel Shapes making sure that you get the adhesive backings as well. Adhere them randomly to the front of the card.