Project Recipe
1) Choose a 6x6 piece of double sided DSP. Cut into 2 pieces of 3"x6".
2) Layer 2 pieces and cut into 1 1/2"x6" strips (you will now have 4 strips that are 1 1/2"/6")
3) cut each of those 4 strips into 3 strips each 1/2"x6". (when finished with this step, you'll now have 12 strips each 1/2"x6"
4) place 3 of these strips parallel (and with same side up) to each other with something loosely holding the tops in place.
5) Weave one strip at midpoint upside down (showing other side of DSP) perpendicular to 3 strips on trimmer. Adhere using a drop of glue at all points of strip to strip contact.
6) Opposite weave next upside down strip above last one. Adhere.
7) Opposite weave 3rd upside down strip below first one.
8) repeat steps 4-7 with other strips. When you finish with this you will have 2 of the items finished from step 7.
9) curl vertical right strip toward horizontal top strip and curl horizontal top strip toward vertical right strip. Adhere using glue dot.
10) Curl horizontal bottom right side toward bottom of vertical right strip and adhere with glue dot.
11) Rotate 180 degrees and repeat steps 9 & 10.
When finished will have 4 curled and adhered petals on one woven piece.
12) repeat steps 4-11 for second woven piece. When finished with this step you will have 2 pieces
13) put 2 pieces back to back and turn one 45 degrees.
14) pull bottom right strip thru top right petal and adhere this strip on top of petal with tear n tape.
15) Repeat this step on opposite corner.
16) repeat steps 14 & 15 on top left petal and bottom right petal.
17) turn snowflake over and repeat threading bottom strips thru petals and adhering.
18) Using Paper Snips trim points off each petal to make fine points.
FINISHED Woven Snowflake!