Fun Fold Card with a flip book inside
Project Recipe
Score the Basic Black base card measuring 24.5cm x 15.5cm at 10cm and 20cm (approx 4" and 8"). on the long edge
lay the base card out flat with the smallest/narrowest panel to the right hand side.
Attach the two pieces of Pretty Peacock 14cm x 9.5cm (3&3/4"x 51/2") to the 1st and 2nd panels.
On the first fold line mark the half way point with a pencil
Close the card.
To the front of the card attach the blue flower Designer Series Paper
Colour your gingham ribbon with the Pretty Peacock Stampin' Blend
On the scalloped contour dies cut rectangle of white measuring 3&3/4" x 2&1/2" stamp as follows:
Solid leaves: Lost Lagoon
Word background - fresh freesia
Stripey element: Berry burst
Thin leaves: Pretty Peacock
Stamp the sentiment on the small piece of white (approximately 1.25cm x 4.5cm.) in pretty peacock ink
Run the bottom edge of the sentiment piece along the pretty peacock ink pad.
On the small piece of black score at:
1.5cm
8.5cm
9.5cm
10.5cm
Fold in half at the 8.5cm mark
Fold the 1.5cm score line the opposite way
with the smallest section on the left folded behind the card attach two pieces of flowery dsp to the largest two sections.
Attach a piece of white 5cm to the large left panel.
Add a berry burst die cut.
Affix the small panel to the base card to the left of the centre fold, centred top to bottom.
the edge should be flush with the fold line.
The fold should be to the left hand side.
Fold the other panels over the top of it so it is hidden by the two panels with the dip on them
Fold the small panel at 8.5cm so the flap closes -
the left edges should line up.
Attach the remaining DSP to the largest panel
on the base card affix a small amount of tear and tape to the top and bottom edges (shortest edges)
Fold it over the flap card and stick down.
The flap should slide back and forth easier when the card closes.
Glue the die cuts to the front of the scalloped contour card
Wrap the gingham ribbon around the scalloped rectangle and tie a bow.
Attach the sentiment with dimensionals
Add bling
Add die cuts as desired to the inside of the card.