Project Recipe
Cut a piece 2" x 4" of the designer series paper knots for the front flap of the card.
Glue this piece to the top flap of the card.
Cut a piece of 4" x 5 1/4" of designer series paper for the inside of the card. Glue this piece to the inside of the card.
Stamp the birds and sponge the edges in Night of Navy ink on a 2 7/8" " x 4" piece of white.
Glue white card stock to 3" x 4 1/8"" Night of Navy.
Glue only the top portion of the above Night of Navy card stock to the top flap of the card.
Make sure you don't have any glue that gets below the flap or the card will not open.
Stamp the light house in blue and cut out using the dies. Sponge the bottom half of the light house with Night of Navy ink.
Attach the light house using dimensionals to card.
Stamp your words in the 1 3/4" circle. Remember you can use both sides if you are not happy the first time.
Adhere the white circle to the Navy Blue circle and attach to the front of the card using dimensionals.
Glue a 2 3/4" x 4 1/4" piece of white card stock to the inside of the card over the designer series paper. Be careful to place this behind the front flap so it does not show when the card is closed.
Glue the Night of Navy wheel to the lower corner of the inside of the card
Cut a small piece of bakers twine and run it though the anchor.
I separate the ends to make it look old.
Attached the anchor trinket using a glue dot.