Wrapped in Plaid

{ tams # 36799 }

Print Recipe

CARD STOCK SIZES
Card Base- 4 1/4" x 11"
Designer Series Paper (DSP) - 4" x 2 3/4"
Accent Strip- 4" x 1/2"
DSP strip for scraps- 2" x 5 1/4"
card stock Scrapes for Trees 3" x 3"
Card Inside 4" x 5 1/4"
Strip - 3/4" x 4"

Score card base at 5 1/2" and fold in half
Designer Series Paper (DSP) has been pre cut to
4" x 2 3/4" and has two sides. You choose which side to use.
Adhere the DSP to the card front using glue.

Designer Series Paper (DSP) has been pre cut to
4" x 2 3/4" and has two sides. You choose which side to use.
Adhere the DSP to the card front using glue.

Glue the strip of 1/2" x 4" Shaded Spruce across the center of the card hiding where the DSP meets in the middle.

I will pass around the scrapes of white, Shaded Spruce and Cherry Cobbler for you to stamp and punch the trees

Use the strip of DSP that is 2" x 5 1/4" and
punch two trees from this piece of scrape DSP. One will be for the outside of the card and one will be for the inside of the card.

Adhere the trees to the center of the card just above the center

I have set up a Stamparatus for you to stamp a sentiment on the whisper white rectangle using Cherry Cobbler ink
I will pass this around the table

Glue white rectangle to Gold Rectangle

Attached gold rectangle to the front of the card using dimensionals.

Card Inside
Stamp the sentiment in Cherry Cobbler on the whisper white card inside.
Glue the strip of DSP on the whisper white.
You may need to cut the DSP down after you glue to the whisper white.
Glue the whisper white to the inside of the card.
Punch a tree from scrap a 2" x 4" DSP. Glue the tree to the inside of the card.