Project Recipe
Card base-5 1/2” x 8 1/2”-Pool Party
First layer-4” x 5 1/4”-soft suede
Second layer- 3 3/4 “ x 5 “-pool party
Third layer 4 x 3 soft suede
Fourth layer 3 3/4” x 2 3/4” designer series paper
Scrap of pool party for scallop circle
Scrap of designer series paper centering bird
Scrap of crumb cake for the words
Card base Score at 4 1/4 inches and fold in half
Glue the embossed piece of pool party to the first layer which is soft suede
I have already embossed using layered leaves embossing folder.
Glue this to the card
Cut a piece of designer series paper to 2 3/4” x 3 3/4”. Glue this to a piece of soft suede that is 4 X 3
Take a 6 inch piece of lace and attach each leg to the back of the card stock using glue dots on both sides. This way you don't waste the ribbon on the back.
Tie a bow in the lace and then tie linen thread around the center of the bow . Tie a square knot in the linen thread. Attach the bow to the card using glue dots
Attach this to the card using dimensional’s
I used the layering circle dies to cut the scallop circle from pool party. I also punched with a 2 1/4 inch circle punch the birds from your paper. If you don’t like my selection of birds you of course can always change it using a 2 1/4 inch punch
Glue the scallop circle to the card
Stamp hello or any word on the label which I have already cut out for you.
You can use early espresso or black ink. I gave you two different sizes just in case you had bigger words
Attach your pearls being careful to grab the glue dots from underneath the pearl.