D ecorated Card Tin using Stampin' Up! products.
Cut card stock and glimmer paper pieces to the following sizes using a Stampin' Trimmer:
- 4" square from Red Glimmer Paper
- 1-1/4" x 3-1/2" from Whisper White Card Stock
- 2" square from Whisper White Card Stock
Cut a 30" piece of Real Red 3/8" Stitched Satin Ribbon. Cut a 30" piece of the gold ribbon from the 3/8" Metallic Ribbon Combo Pack.
Lay the gold ribbon on top of the red ribbon. Wrap the ribbons around the center of the Card Tin and tie a knot. Get the ribbons as tight to the tin as you can. Trim the ends. Slide the knot to the right side of the box.
Pick out the large detailed heart thinlit from the Bloomin' Heart Thinlits. Place the square of Red Glimmer Paper upside down on the Precision Base Plate on top of the Big Shot Platform. Place the large detailed heart thinlit on top in the center. Place another Cutting Pad on top and run through the Big Shot a couple of times. Use the Die Brush to remove the tiny pieces. Placing the glimmer paper upside down to cut it helps to protect the cutting edge of your dies.
Mount the banner with leaves at either end image from the Bloomin' Love Photopolymer Stamp Set on Block H. Ink it up with the VersaMark Pad. Stamp it in the center of the long, skinny white rectangle.
Sprinkle on Gold Stampin' Emboss Powder and tap off excess. Return excess powder to the container.
Use the Heat Tool to melt the powder on the banner image. Make sure all the powder is melted (shiny and smooth).
Pick out the large banner framelit from the Large Numbers Framelits. Place the embossed white rectangle on the Cutting Pad on top of your Magnetic Platform on your Big Shot. Place the large banner framelit on top so the embossed banner image is centered in the framelit. Place the other Cutting Pad on top and run through the Big Shot.
Use a strip of Tear & Tape Adhesive to adhere the banner to the center of the detailed glimmer heart cut out.
Mount the "from my heart to yours" image from the Better than Email Photopolymer Stamp Set on Block A. Use the brush tip of the Real Red Marker to ink up all of the stamp except for the copyright information. Breathe on the stamp to make sure the ink is moist and stamp it in the center of the small white square.
Pick out the straight edged heart framelit that cuts out a heart that is 1-8/16" wide from the Sweet & Sassy Framelits. Place the stamped white square on the Cutting Pad on top of your Magnetic Platform on your Big Shot. Place the straight edged heart framelit on top so the sentiment is centered in the framelit. Place the other Cutting Pad on top and run through the Big Shot.
Use the side of the brush tip of the Real Red Marker to outline the edges of the heart cut out.
Use Stampin' Dimensionals to adhere the sentiment heart to the center of the banner on the detailed glimmer heart cut out.
Put small pieces of Tear & Tape Adhesive on the back of the detailed glimmer heart cut out wherever you can fit them (behind the solid flowers and the sentiment heart and banner). Remove the protective backing from all the Tear & Tape pieces and adhere the heart to the front of the Card Tin so it is centered over the ribbon and centered side to side.