Project Recipe
Card #1
Cut mint macron cardstock to 5 inches x 3.75 inches
Cut very vanilla cardstock to 5 1/2 inches x 4 1/4 inches (or fold 8 1/2 x 11 inch piece to create a card base)
Emboss cardstock using Layered Leaves embossing folder.
Use largest Oval from Stitched Framelits to cut center out of the middle of embossed card stock. Cutting the long way. If done correctly you should have about 3/4 of an inch margin left on top and bottom and about 1/2 inch margin on left and right of cardstock.
Get pre-printed flower piece from your paper pumpkin kit which is 3 1/2 inches by 3 1/4 inches.
Adhere to the wrong side of the mint macron card stock so the flowers are showing through the hole in the front and there are no empty spaces showing though the hole.
Use white string from paper pumpkin kit - one inch from the bottom of the mint macaroon embossed cardstock - wrap it around twice, knot and tie in a bow. The bow should be on the right edge of the cardstock. Trim bow strings to desired length. This is your finished card front.
Adhere your finished card front to the whisper white cardstock, leaving 1/4 inch margin on each edge so it is centered.
Brush wink of stella on the flowers.
* End of card 1 *
Card #2
Materials
Flirty Flamingo Cardstock
Whisper White Cardstock
Flirty Flamingo Classic Stampin Pad
Old Olive Classic Stampin Pad
Rhinestones
Stamp Blocks or Stamparatus
Cut Flirty Flamingo cardstock in two pieces -
One - 5 1/2 x 4/14 inches
One -
Cut whisper white cardstock to 5 1/4 x 4 inches
Get flower stamp from paper pumpkin set and mount it on a stamp block or the Stamparatus.
Press Flirty Flamingo ink pad on stamp until fully covered and stamp to one corner of the whisper white cardstock. The edge of the flower should touch or almost touch the edge the cardstock. Then stamp the flower in Flirty Flamingo on the opposite corner the same way.
Use the leaves stamp from Paper Pumpkin kit. Stamp the leaves using Old Olive. Stamp one leaf stamp on the left side and one on the right side of each of the flowers.
Using the rectangle stitched framelits, cut a whole in the whisper white card stock leaving ___ inches on all four sides (___ sized framelit).
You will now have two pieces - a rectangle and a frame.
Adhere the smaller stamped whisper white cardstock to the smaller flirty flamingo cardstock piece leaving 1/8 inch margin on all four sides.
Put adhesive on the back of the smaller flirty flamingo cardstock piece and adhere on the larger whisper white cardstock. Be careful to line the corners up with the flower stamped in the corners.
Put adhesive on the back of the larger whisper white cardstock and adhere to the larger flirty flamingo cardstock, being sure to center it so there is 1/8 inch margins on all four sides.
Place one rhinestone in the center of each flower.
*END of Card 2 *
Card 3