A soft and pretty thank you card using Stampin' Up! products.
Project Recipe
Cut card stock, designer paper, and glimmer paper pieces to the following sizes using a Stampin' Trimmer:
- card from Soft Sky Card Stock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" from Blushing Bride Card Stock
- 3-7/8" x 5-1/8" from multicolored butterflies on tan background design of paper from Falling in Love Designer Series Paper
- 2-1/2" x 3" from Soft Sky Card Stock
- 1/4" x 3-7/8" from Sweet Sugarplum Glimmer Paper from 6" x 6" Glimmer Paper Assortment Pack
- 1-1/4" x 2-1/4" pieces of Sweet Sugarplum Card Stock, Sahara Sand Card Stock, Very Vanilla Card Stock, Blushing Bride Card Stock, and Sweet Sugarplum Glimmer Paper
Use the Fine-Tip Glue Pen to adhere the long, skinny strip of Sweet Sugarplum Glimmer Paper to the bottom of the Falling in Love Designer Series Paper rectangle so it is about 3/8" up from the bottom.
Adhere the designer paper to the large Blushing Bride rectangle and then to the front of the Soft Sky card.
Mount the large dotted oval outline image from the That's the Tag Photopolymer Set on Block D. Ink it up with the Sweet Sugarplum Ink Pad. Stamp it in the center of the Soft Sky rectangle.
Mount one of the three line sentiments of your choice from the That's the Tag Photopolymer Set on Block A. Ink it up with the Sweet Sugarplum Ink Pad. Stamp it inside the stamped oval image so it is centered up and down but on the left side of the oval.
Pick out the large open oval with the tag hole framelit from the Timeless Tags Thinlits. Place the stamped Soft Sky rectangle on the Cutting Pad on top of your Magnetic Platform on your Big Shot. Place the oval framelit on top so the stamped oval image is centered in the framelit. Place the other Cutting Pad on top and run through the Big Shot.
Pick out the curved line of tiny butterflies thinlit from the Timeless Tags Thinlits. Place the small piece of Blushing Bride card stock on the Precision Base Plate on top of the Platform on your Big Shot. Place the butterflies thinlit on the card stock. Place a Cutting Pad on top and run through the Big Shot. Use the Die Brush to remove the tiny butterflies.
Repeat Step 7 above with each of the other pieces of card stock (Sweet Sugarplum, Sahara Sand, and Very Vanilla) and the Sweet Sugarplum Glimmer Paper.
Pick out 6 of the little butterflies you've cut out and adhere them in an arch to the right side of the sentiment on the oval tag. Use the Fine-Tip Glue Pen to adhere them.
Pick out three of the larger remaining butterflies and adhere them in an overlapping group to the left side of the glimmer paper strip on the front of the card. Use the Fine-Tip Glue Pen to adhere them.
Use the remaining butterflies to decorate the inside of the card if you want or save them for another project.
Cut a 4" piece of the Sweet Sugarplum Ribbon from the Succulent Garden 3/8" Ribbon Combo Pack. Thread it through the hole in the top of the Soft Sky tag.
Cut a 4" piece of the Very Vanilla 1/4" Satin Ribbon. Tie it in a knot around the Sweet Sugarplum ribbon as close as you can get to the tag. Trim the ends of both ribbons.
Use Stampin' Dimensionals to adhere the tag to the center of the card front.