F un Halloween card using Stampin' Up! products.
Project Recipe
Cut cardstock and designer paper pieces to the following sizes using a Paper Trimmer:
- card from Pumpkin Pie Cardstock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" from Crushed Curry Cardstock
- 2-1/8" x 5-1/4" from Basic Black Cardstock
- 2" x 5-1/4" of jars filled with spooky items on light tan design from Monster Bash Designer Series Paper, cut so the jars are vertical on the vertical strip
-1-3/4" x 3-1/4" from Pumpkin Pie Cardstock
- 1-3/4" x 2-1/2" from Crushed Curry Cardstock
Insert the large Crushed Curry rectangle into the Hammered Metal 3D Embossing Folder. Use the line drawn on the front of the folder to help you line the cardstock up straight. Place the folder with the paper inside on your die cutting and embossing tool and run through the machine.
Adhere the strip of Monster Bash Designer Paper to the center of the Basic Black strip.
Adhere the matted strip of designer paper to the left side of the dry embossed Crushed Curry rectangle leaving about 1/4" of Crushed Curry showing on the left edge. Use Paper Snips to trim off any excess designer paper/black cardstock.
Adhere the dry embossed Crushed Curry rectangle with designer paper attached to the front of the Pumpkin Pie card.
As you are ready to stamp using the Tags Tags Tags Photopolymer Set, place the cardstock on the Stampin' Pierce Mat. Using the mat will help you get a cleaner image each time you stamp. Put a piece of Grid Paper on top to protect the mat from ink.
Mount the set of three Halloween tags image from the Tags Tags Tags Set on Block I. Ink up only the "It's All about the Candy!" image on the end using the Memento Ink Pad. Stamp the tag in the center of the small Crushed Curry rectangle.
Pick out the set of 3 tags die from the Trio of Tags Dies. Put it on top of the stamped tag on a platform on your cutting and embossing tool so the tag with the three little holes cut in each end is centered over the tag. Run through the tool. Use the paper-piercing tool on the Take Your Pick to remove the pieces if needed.
Unlock the Everyday Label Punch. Slide the Pumpkin Pie strip into the punch. Punch.
Adhere the tag cut out to the center of the label punch out.
Use Stampin' Dimensionals to adhere the matted tag to the front of the card so it is centered over the right side of the matted designer paper strip about 3/4" from the bottom edge of the card.
Use the brush tip of the Dark Pumpkin Pie Stampin’ Blends to color three large Basic Rhinestone Jewels while on the sheet.
Use the mini spatula on the Take Your Pick tool to pick up the colored jewels being sure to get the adhesives as well. Adhere two at either end of the black/Crushed Curry tag punch out. Adhere the third in the upper right corner of the card front.