D ecorated Acetate Card Box filled with Halloween treats using Stampin' Up! products.
Project Recipe
Cut cardstock and designer paper pieces to the following sizes using a Paper Trimmer:
- 4-1/4" x 5-5/8" from Pumpkin Pie Cardstock
- 4-1/8" x 5-1/2" of books design from Monster Bash Designer Series Paper, cut so the books are horizontal on the horizontal rectangle
- 1-3/4" x 3-1/4" from Crushed Curry Cardstock
- 1-3/4" x 2-1/2" from Pumpkin Pie Cardstock
Fold an Acetate Card Box together, fill it with treats, and close the box.
Adhere the large rectangle of books Monster Bash Designer Paper to the large Pumpkin Pie rectangle.
Use Tear & Tape Adhesive strips to adhere the matted designer paper to the top of the card box.
As you are ready to stamp using the Tags Tags Tags Photopolymer Set, place the cardstock on the Stampin' Pierce Mat. Using the mat will help you get a cleaner image each time you stamp. Put a piece of Grid Paper on top to protect the mat from ink.
Mount the set of three Halloween tags image from the Tags Tags Tags Set on Block I. Ink up only the "It's All about the Candy!" image on the end using the Soft Suede Ink Pad. Stamp the tag in the center of the small Pumpkin Pie rectangle.
Pick out the set of 3 tags die from the Trio of Tags Dies. Put it on top of the stamped tag on a platform on your cutting and embossing tool so the tag with the three little holes cut in each end is centered over the tag. Run through the tool. Use the paper-piercing tool on the Take Your Pick to remove the pieces if needed.
Unlock the Everyday Label Punch. Slide the Crushed Curry strip into the punch. Punch.
Adhere the tag cut out to the center of the label punch out.
Use the small hole punch to punch a hole through the matted tags at the top.
Cut a 4" piece of Crushed Curry 3/8" Crinkled Seam Binding Ribbon.
Thread the tag onto the ribbon and get it centered.
Cut a 3-1/2" piece of the Crumb Cake twine from the Nature's Twine.
Tie the twine in a knot around the ribbon just above the tag. Trim the ends of the twine and ribbon. Fray the ends of the twine.
Use Black Stampin' Dimensionals to adhere the matted tag with ribbon attached to the front of the box at an angle on the lower left side.
Use the mini spatula on the Take Your Pick tool to pick up a large gray circle shape and a small gray circle shape from a sheet of Monster Bash Enamel Shapes being sure to get the adhesives as well. Adhere them to the bottom of the tag as shown.