C
ombine the Swirly Scribbles Thinlets with Snow Place stamps and Snow Friends framelits for an impressive Christmas greeting!
My Online Store:http://www.stampinup.net/esuite/home/carolpayne/
Email: carol@carolpaynestamps.com
Call or text: 618-237-6281
NOTE: Always put the Stampin' Pierce My Stampin' Up!-Only Blog: www.carolpaynestamps.com
mat under your card stock when stamping with Photopolymer stamps to achieve a well-stamped image.
Project Recipe
Dimensions:
Night of Navy card base: 4 1/4" x 11", scored & folded at 5 1/2"
Floral Boutique Designer Paper layer: 4" x 5 1/4"
Night of Navy front layer: 3 1/2" x 4 3/4"
Whisper White inside layer: 4" x 5 1/4"
Dazzling Diamonds Glimmer: 3" x 3", 2 1/2" x 2 1/2", 1 5/8" x 1 5/8"
Basic Black for arms: 1 5/8" x 5 1/4"
Basic Black for hat: scrap about 1 1/2" x 2"
Whisper White for scarf & Santa hat: 2 3/4" x 4 1/4"
Whisper White strip for greeting: 3/4" x 3 1/2"
Cherry Cobbler Designer Paper to line envelope: 2 1/4" x 5 5/8"
Adhere Floral Boutique paper to card front with SNAIL.
Emboss Night of Navy layer with Sparkle folder.
Adhere to card front with SNAIL.
Peel the plastic backing off of all three Dazzling Diamonds Glimmer squares.
Cut all three sizes of Dazzling Diamonds Glimmer Paper with the corresponding Swirly Scribbles circle thinlets. Lay paper-side down on Die Brush foam pad. Roll Die Brush over the metal thinlet several times to release the paper from the die. Adhere to card front in a snowman with glue dots.
Cut top hat from black scrap. Adhere to snowman with a dimensional. Add row of connected rhinestones to hat brim.
Stamp scarf with Cherry Cobbler ink on white scrap. Cut with scarf framelit. Adhere to snowman with glue dots.
Punch arms from black card stock with Tree Builder Punch. Adhere with glue dots.
Stamp greeting on white strip with Night of Navy ink.
Snip ends of strip into banner points with Paper Snips. Adhere with dimensionals.
Stamp inside white layer with sentiment, snowflakes, and baby snowman using Night of Navy ink.
Adhere inside card with SNAIL.
Stamp Santa hat with Cherry Cobbler ink on white scrap. Cut with Santa hat framelit. Adhere with a glue dot.
Punch one end of 2 1/4” x 5 5/8”” of DSP with Gift Bag Punch Board, lining up the edge of the paper with the “Start” line on the board before punching. Flip paper end-over-end and line up the opposite side of the paper with the “Start” line before punching again. Adhere inside envelope just below the glue line using a line of SNAIL ONLY along the top edge of the liner. Fold envelope flap down to crease the liner and push it farther down into the envelope. Stamp the envelope to match your card and you are done!