P retty gift label using Stampin' Up! products.
Project Recipe
Cut cardstock and designer paper pieces to the following sizes using a Paper Trimmer:
- 4" x 5-1/2" of diagonal dashed pink lines on red background design from Sweet Stockings 12" x 12" Designer Series Paper
- 3-1/2" x 4-3/4" from Basic White Cardstock
- 1" x 2-1/4" from Basic White Cardstock
- 1" square from Cherry Cobbler Cardstock
Pick out the large, open, ornate rectangle die that cuts out a rectangle that is 3-7/8" x 5-3/8" from the Ornate Layers Dies. Put it on top of the designer paper rectangle on a platform on your Stampin' Cut & Emboss Machine. Run through the machine a couple of times. Use the Take Your Pick and Take Your Pick Die Brush Tip to remove the pieces.
Mount the large, outline heart with flowers image from the Strong Of Heart Set on Block E. Ink it up with the Memento Pad. Stamp it on the horizontal white rectangle so it is centered top to bottom and about 3/8" from the left side.
Mount the large, brushstroke heart image from the Strong Of Heart Set on Block E. Ink it up with the Blushing Bride Ink Pad. Stamp it on the horizontal white rectangle so it is centered in the outline heart.
Pick out the stitched rectangle die from the Stitched Rectangles Dies that cuts out a rectangle that is 3" x 4-3/8". Put it on top of the stamped white rectangle on a platform on your Stampin' Cut & Emboss Machine so the heart is centered top to bottom and close to the left edge. Run through the machine.
Put the stamped white rectangle cut out on some Grid Paper to protect your work surface. You need to make sure that you protect your work surface with paper as the Stampin' Blends Markers do bleed through.
Use the Dark and Light Cherry Cobbler Stampin' Blends to color in the flowers.
Use the Dark and Light Mossy Meadow Stampin' Blends to color in the leaves.
Adhere the stamped and colored white rectangle cut out to the center of the ornate designer paper rectangle cut out and then to the front of the package.
Mount the sentiment of choice from the Peaceful Moments Set on an appropriate size block. Stamp it on the small white rectangle.
Use Paper Snips to cut out the sentiment by hand getting close to the edges of the letters.
Use Mini Stampin' Dimensionals to adhere the sentiment cut out to the label so it overlaps the right edge of the heart outline near the center.
Pick out the smallest heart die from the Give It A Whirl Dies. Put it on top of the small Cherry Cobbler square on a platform on your Stampin' Cut & Emboss Machine. Run through the machine.
Use a Mini Stampin' Dimensional to adhere the small heart cut out to the upper right corner of the white rectangle cut out.
Cut a 4" piece of the Cherry Cobbler & Gold 1/2" Metallic Ribbon.
Tie a half knot in the center of the ribbon. Trim the ends.
Use a Mini Glue Dot to adhere the ribbon knot to the label in the lower right corner of the white rectangle cut out.