P retty sympathy/thinking of you card using Stampin' Up! products.
Project Recipe
Cut cardstock pieces to the following sizes using a Paper Trimmer:
- card from Cherry Cobbler Cardstock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" from Blushing Bride Cardstock
- 3-3/4" x 5" from Basic White Cardstock
- 4-1/2" square from Blushing Bride Cardstock
Mount the "thinking of you with all my heart" sentiment from the Peaceful Moments Set on Block C. Ink it up with the Cherry Cobbler Ink Pad. Stamp it on the horizontal white rectangle so it is about 5/8" from the bottom edge and about 3/4" from the right edge.
Adhere the stamped white rectangle to the center of the Blushing Bride rectangle and then to the front of the Cherry Cobbler card.
Mount the large, brushstroke heart image from the Strong Of Heart Set on Block E. Ink it up with the Cherry Cobbler Ink Pad. Stamp it in the center of the 4-1/2" Blushing Bride square. WITHOUT RE-INKING, shift the stamp down and to the right a very small amount and stamp again.
Pick out the large heart surrounded by foliage and flowers from the Floral Heart Dies. Put it on top of the stamped heart image on a platform on your Stampin' Cut & Emboss Machine so the heart portion of the die is centered over the stamped heart. Run through the machine. Use the Take Your Pick Die Brush Tip and paper-piercing tool on the Take Your Pick to remove the pieces. Keep the large, solid heart cut out and the foliage and flowers around an empty heart cut out.
Use Paper Snips Scissors to cut some of the foliage and flowers off from the rest of the cut out so you have two smaller pieces.
Put adhesive on the back of the solid heart cut out and adhere it to the tops of the foliage and flower cut down pieces as shown. Be sure to cover any stamping along the edges of the cut down foliage and flower pieces.
Add additional Stampin' Seal to the back of the solid heart and some Multipurpose Liquid Glue or Fine-Tip Glue Pen to the backs of the foliage and flower cut down pieces. Adhere the heart with foliage and flowers attached to the front of the card so it is just to the left of the sentiment as shown.
Cut a 3-1/2" piece of the White 3/8" Glittered Organdy Ribbon.
Tie a half knot in the center of the ribbon. Trim the ends.
Use a Mini Glue Dot to adhere the ribbon knot to the card front at an angle between the top left side of the sentiment and the bottom right edge of the heart as shown.
Use the mini spatula on the Take Your Pick to carefully peel up a large Petal Pink gem from a sheet of Elegant Faceted Gems making sure that you get the adhesive backing as well. Adhere it to the top left lobe of the heart image.
Use the mini spatula on the Take Your Pick to carefully peel up 2 small Petal Pink gems from a sheet of Elegant Faceted Gems making sure that you get the adhesive backings as well. Adhere them randomly to the front of the card on the right side as shown.