T
oday’s card is a simple card to make…Stampin’ Up!® have done most of the work for us.
Here I have used the stunning and elegant Forever Gold Die-cut Specialty Designer Series Paper. I have used one of the panels on my card front and anything else you put with it needs only to be simple.
Project Recipe
Metric A4 Measurements.
Cut out each piece listed below...
CARDSTOCK - SOFT SEA FOAM
Card Base - 10.5cm x 29.8cm, score 14.9cm
Mat 2 - 8.5cm x 12.3cm
Banner - 1.9cm x 9cm
Insert 1 - 9.7cm x 14.1cm
CARDSTOCK - JUST JADE
Mat 3 - 8.7cm x 12.5cm
Leaf - 10.5 cm x 14.9cm
Insert 2 - 10cm x 14.4cm
CARDSTOCK - WHISPER WHITE
Leaf - 7cm x 10cm
Imperial US Letter Size cardstock
CARDSTOCK - SOFT SEA FOAM
Card Base - 8 ¼" x 11", score 5 ½"
Mat 2 - 3 ⅜" x 4 ⅞"
Banner - ¾" x 3 ½"
Insert 1 - 3 ⅞" x 5 ⅛"
CARDSTOCK - JUST JADE
Mat 3 - 3- 7/16" x 4- 15/16"
Leaf - 4 ¼" x 5 ½"
Insert 2 - 4" x 5 ¼"
CARDSTOCK - WHISPER WHITE
Leaf - 3" x 4"
For this card you will require from the Forever Gold Specialty Designer Series Paper...
1 x Decorative panel
1 x small Gold Leaf
Forever Greenery Trim Combo
15cm (6") of the Very Vanilla Trim
20cm (8") Gold Trim
Cut out each piece listed in the measurements above and score/ fold card base.
Leaf - Stamp Round Leaf image onto Whisper White Cardstock with Cherry Cobbler Ink. Die cut with coordinating die from Forever Flourishing Dies
Banner - Stamp sentiment using Memento Tuxedo Black, stamping to the left of the banner. With the Lovely Labels Pick A Punch, punch each end of the Banner.
Card Front- adhere the Soft Sea Foam mat to the Just Jade mat. Then attach the Gold Laser Cut panel to the card front, you can do this by using a Silicon Mat and sponge to dab the Multi-Purpose Glue onto the back of Laser cut panel.
Die cut Leaf - cut a large leaf die for card front & another for card Insert. The 2nd leaf for the Insert only needs to be half of the leaf branch.
Layer the 3 leaves - Just Jade leaf, small gold leaf (from the Gold Laser Cut leaves) and Cherry Cobbler leaf, adhering them together using glue dots. With glue dots attach leaves to the card front.
Add dimensionals to the back of the card front and attach to the card base.
Place dimensionals onto the back of the banner and attach just at the bottom edge of stems.
Fold 15cm of Very Vanilla Trim In half and wrap the Gold trim around approx. 1.5cm (½”) from folded edge and tie a bow. Attach to top of stems with a glue dot.
Congratulations…you have completed your card.