F un Halloween card using Stampin' Up! products.
Project Recipe
Cut cardstock, Glimmer Paper, and designer paper pieces to the following sizes using a Paper Trimmer:
- card from Pumpkin Pie Cardstock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" of spiderwebs on gray background design from Monster Bash Designer Series Paper
- 1-3/4" x 5-1/4" of orange and white bats and black script on gray background design from Monster Bash Designer Series Paper, cut so the script is horizontal on the vertical strip
- 1/4" x 5-1/4" from Pumpkin Pie Cardstock
- 2-1/2" x 3-1/4" from Pumpkin Pie Cardstock
- 2" circle of large haunted house image punched out from haunted houses design from Monster Bash Designer Series Paper
- 1-1/4" x 3-1/4" from Sparkle Glimmer Paper
- 1-3/4" x 2-1/2" from Pumpkin Pie Cardstock
Adhere the strip of bats design Monster Bash Designer Paper to the left side of the spiderwebs design rectangle of Monster Bash Designer Paper.
Use the Fine-Tip Glue Pen or Multipurpose Liquid Glue to adhere the thin strip of Pumpkin Pie Cardstock to the designer paper rectangles so it covers the seam between the two pieces.
Adhere the designer paper rectangles with cardstock strip attached to the front of the Pumpkin Pie card.
If you haven't already done son, unlock the 2" Circle Punch. Hold it upside down so you can see the punching area. Slide the haunted house designer paper into the punch and get one of the large haunted houses centered in the punching area. Punch.
Unlock the 2-1/4" Circle Punch. Slide the long strip of Pumpkin Pie into the punch. Punch.
Adhere the haunted house circle punch out to the center of the Pumpkin Pie circle punch out.
Adhere the matted haunted house circle punch out to the front of the card so the left side just overlaps the left edge of the thin Pumpkin Pie strip and it is about 1-1/4" from the bottom.
Mount the "Have A Spooktacular Halloween" sentiment from the Spooktacular Bash Set on Block C. Ink it up with the Memento Pad. Stamp it in the center of the remaining Pumpkin Pie rectangle.
Pick out the stitched, tombstone shaped die from the Ornate Frames Dies. Put it on top of the stamped sentiment on a platform on your cutting and embossing tool so the sentiment is centered. Run through the tool.
Adhere the sentiment cut out to the front of the card so it is centered side to side under the bottom of the haunted house in the circle punch out.
Unlock the Twinkle Builder Punch. Hold it upside down so you can see the punching area. Slide the strip of Sparkle Glimmer Paper into the punch and get it positioned so you will punch out the crescent moon. Punch.
Use small pieces of Tear & Tape Adhesive to adhere the moon punch out to the the front of the card so it overlaps the circle punch outs and hides the moon image on the designer paper in the smaller circle. The open side of the crescent moon should be facing left.
Cut a 3" piece of Basic Black 3/8" Scalloped Edge Ribbon. Tie a half knot in the center of the ribbon. Trim the ends.
Use a Mini Glue Dot to adhere the ribbon knot to the front of the card at a slight angle in the junction between the left side of the matted circle punch out and the upper left side of the sentiment cut out.