A nother card for the RemARKably Creative Blog Tour - Succulent Garden Suite using Stampin' Up! products.
Project Recipe
Cut card stock and designer paper pieces to the following sizes using a Stampin' Trimmer:
- card from Calypso Coral Card Stock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" from Sweet Sugarplum Card Stock
- 3-3/4" x 5" of tiny flowers in brown, purple, and orange on white background design of paper from Succulent Garden Designer Series Paper
-1-5/8" x 3-3/4" from Calypso Coral Card Stock
- 2" x 4-1/2" from Whisper White Card Stock
Mount the curved diamond frame image from the So in Love Set on Block B. Ink it up with the Calypso Coral Ink Pad. Stamp it in the center of the white strip.
Mount one of the shorter sentiments from the So in Love Set on Block B. Ink it up with the Sweet Sugarplum Ink Pad. Stamp it in the center of the stamped frame image.
Mount set of 4 little flowers image from the So in Love Stamp Set on Block A. Use the brush tips of the Markers to ink up the flowers. The two smaller flowers get inked up with the Tip Top Taupe Marker and the other two flowers get inked up with the Calypso Coral and Sweet Sugarplum Markers (one each). Stamp onto scratch paper. Then, breathe on the stamp to make sure the ink is wet and stamp again in the center of the frame image over the sentiment.
Place the stamped strip of Whisper White Card Stock on the Precision Base Plate on the Big Shot Platform. Place the long skinny So Detailed Thinlit with the cut out in the middle on top of the card stock so the cut out is centered over the framed sentiment. Place one Cutting Pad on top and run it through the Big Shot. Use the Die Brush to remove the card stock from the die if needed and to remove all the little pieces.
Put a little SNAIL Adhesive on the back of the framed sentiment on the white cut out. Place the white cut out upside down on one side of a Silicone Craft Sheet. Cut a Stamping Sponge into quarters and clamp the triangle edge of one quarter in a large binder clip. Squeeze a small amount of Multipurpose Liquid Glue on one corner of the Silicone Craft Sheet. Dab the sponge into the glue and then lightly onto the back of the white cut out on the delicate details. Flip the white cut out over and adhere it across the center of the Calypso Coral rectangle.
Use Paper Snips to trim off excess white card stock on either side of the Calypso Coral layer.
Adhere the Calypso Coral layer to the Succulent Garden Designer Series Paper layer so it is about 1" from the top.
Adhere the designer paper to the Sweet Sugarplum rectangle and then to the front of the Calypso Coral card.
Cut a 4" piece of the Sweet Sugarplum ribbon from the Succulent Garden 3/8" Ribbon Combo Pack. Tie in a half knot. Trim the ends. Adhere to the card front to the bottom right of the center image using a Mini Glue Dot.