S haker card with spring cherry tree in bloom using Sheltering Tree stamp set
Project Recipe
Cut Blushing Bride for 5 1/2 X 4 1/4" card
Cut Whisper White 5 1/4 X 4" and 4 X 4"
Cut Window Sheet 4 X 4"
Cut foam ring from foam plate or foam packing sheet using circle Framelits size 3 1/2" and 3 1/4"
Using 1/8" punch, punch a "pinch" of confetti from Bushing Bride scrap.
Count out 10 sequins from Blushing Bride sequin trim.
Stamp tree trunk in Early Expresso.
Using SMALL leaves stamp, stamp randomly and sparsely with Pear Pizzazz. Stamp off for a few shaded leaves.
Glue foam ring carefully around image.
Fill image with confetti dots and 10 sequins.
Apply glue to top of foam ring.
Adhere four dimensionals to the four corners of the clear window sheet.
Carefully attach to top of foam ring and white 4 x4 stamped image.
Using the 3 1/4" circle Framelit, cut a window in the 5 1/4 X 4" white sheet .
Clean small leaf stamp and stamp in Blushing Bride at bottom right corner.
Run two layers of gold baker's twine around bottom of white. Tie off.
Attach bow paper clip.
Attach 4 dimensionals.
Run glue snail across four edges of clear window.
Attach white frame to clear window shaker and THEN peel off dimensionals.
Carefully position on front of card. Add glue behind shaker and line up so dimensionals on the pink card front.
Cut Pink Glimmer Paper in a 1/2" strip X 5 1/4"
Notch bottom end.
Using a dimensional on notched end and glue on rest of strip, adhere to left front of card.
Inside, stamp greeting and glue one accent Blushing Bride sequin.