S oft and pretty birthday card using Stampin' Up! products.
Project Recipe
Cut cardstock and designer paper pieces to the following sizes using a Stampin' Trimmer:
- card from Powder Pink Cardstock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" of the white shell flowers on Powder Pink background design from the Fresh Florals Designer Series Paper Stack, cut the paper so the rows of shell flowers are vertical
- 2" x 5" from Whisper White Cardstock
- 2" square from Powder Pink Cardstock
Cut a 6" piece of Berry Burst 1/2" Finely Woven Ribbon. Fold the ribbon in half lengthwise on one end. Cut a notch in the end by using Paper Snips to cut at a sharp angle towards the fold in the ribbon cutting off about 1/2" of ribbon.
Lay the ribbon piece across the center of the designer paper with the flat end going off the top edge. Flip the designer paper over and fold the end of the ribbon over. Adhere the end of the ribbon in place with a piece of Tear & Tape Adhesive.
Remove the protective backing from the Tear & Tape strip and add more SNAIL to the back of the designer paper. Adhere the designer paper to the front of the Powder Pink card.
Put a line of SNAIL in the center of the designer paper under the ribbon. Adhere the ribbon to it.
Unlock the Banner Triple Punch. Slide the strip of white cardstock into the punch as far as it will go. Punch.
Mount the sentiment from the Ribbon of Courage Set on Block B. Ink it up with the Berry Burst Ink Pad. Stamp it in the center of the bottom of the white banner about 3/8" from the top of the notch.
Adhere the stamped banner to the front of the card so it is centered over the ribbon.
Mount the larger heart image from the Ribbon of Courage Set on Block B. Ink it up with the Powder Pink Ink Pad. Stamp it in the center of the Powder Pink square.
Pick out the straight edged heart framelit from the Sweet & Sassy Framelits that cuts out a straight edged heart that is 1-1/2" wide. Place the stamped heart image on the Cutting Pad on top of the Magnetic Platform on the Big Shot. Place the heart framelit on top so it is centered over the stamped heart image. Place another Cutting Pad on top and run through the Big Shot.
Adhere the heart to the top center of the banner.
Pick out a Berry Burst bow from the 2017-2019 In Color Bitty Bows. Peel off the protective backing on the adhesive on the back of the bow and adhere the bow to the center of the heart image.