P retty, monochromatic thank you card using Stampin' Up! products.
Project Recipe
Cut cardstock pieces to the following sizes using a Paper Trimmer:
- card from Soft Succulent Cardstock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" from Soft Succulent Cardstock
- 3/4" x 2-1/2" from Very Vanilla Cardstock
Mount the large spray of flowers on stems with leaves image from the Quiet Meadow Set on Block I. Ink it up with the Soft Succulent Ink Pad. Stamp it on the large, vertical Soft Succulent rectangle so it is about 1/2" from the top edge and about 3/8" from the left edge. Re-ink the stamp and stamp it again slightly lower and to the right of the first image.
Mount the text block image from the Quiet Meadow Set on Block H. Ink it up with the Soft Succulent Ink Pad. Stamp once on Grid Paper, then WITHOUT RE-INKING, stamp it across the bottom of the stamped, vertical Soft Succulent rectangle so the right edge goes off the right side of the cardstock and the bottom edge is about 1/2" from the bottom. Re-ink the stamp, stamp off on Grid Paper, and stamp it again on the same line so you fill in the space on the left side. The left edge will go off the left edge of the cardstock.
Mount the splatter image from the Quiet Meadow Set on Block H. Ink it up with the Soft Succulent Ink Pad. Stamp once on Grid Paper, then WITHOUT RE-INKING, stamp it randomly all over the top of the stamped, vertical Soft Succulent rectangle. Let some of the images go off the left, top, and right edges and stamp at a slightly different angle each time. Repeat until you have the splatter coverage you want, just remember to stamp off each time before stamping on the cardstock.
Cut a 10" piece of the gold Simply Elegant Trim.
Fold the trim in half.
Lay the trim across the bottom of the stamped cardstock rectangle so it is centered across the text block images. Flip the cardstock over and fold the ends of the trim over. Adhere the ends of the trim in place with pieces of Tear & Tape Adhesive.
Remove the protective backing from the Tear & Tape strips and add Stampin' Seal to the back of the Soft Succulent rectangle. Adhere it to the front of the Soft Succulent card.
Unlock the Banners Pick A Punch. Slide one short edge of the thin vanilla strip into the right side of the punch (the side of the punch with the inward notch) as far as it will go and get it centered. Punch.
Mount the one line sentiment of your choice from the Quiet Meadow Set on Block G. Ink it up with the Soft Succulent Ink Pad. Stamp it in the center of the punched vanilla strip so the notch is on the right side.
Use Stampin' Dimensionals to adhere the sentiment punch strip to the front of the card so it is centered over the trim pieces on the left side with about 1/2" between the flat, left end of the sentiment punch out and the left side of the card.
Cut an 8" piece of the gold Simply Elegant Trim.
Tie a small bow in the center of the trim. Trim the ends.
Use a Mini Glue Dot to adhere the small bow at a slight angle to the card front so it is centered inside the notch of the sentiment punch out.
Use the mini spatula on the Take Your Pick to carefully peel up 3 different sizes of Champagne Rhinestone Basic Jewels from the sheet making sure that you get the adhesive backings as well. Adhere them randomly to the front of the card around the stamped flowers on the right side.