SPOOKY FUN Card 3
2) 4 x 5.25 Whisper White Panels
4 1/8 X 5 3/8 Basic Grey (mat)
4 x Basic Gray panel for cutting
DSP 4 x 3
Scrap of Smoky Slate
Post it notes
Glitter oval and scallop mat are pre-cut
Cut the Basic Grey panel using the DSP to choose height of fence piece. Align the bottom of the die so that it is completely on the DSP. The die will make an imprint on the DSP to mark where to cut if the line is too light make a pencil mark along the space between the fence and the die where you need to cut away the DSP.
Cut the tree from the opposite edge just above the fence top.
Adhere the DSP so that it runs right along the edge below the fence as seen. Snail of fast fuse is fine.
Tie gray and black twine around panel and tie a bow or knot.
Stamp Ghosts on Whisper white and on pot-it note 2 times
cut out post-it note ghosts and mask off the ghosts on front panel.
sponge pouncing over the ghosts and across top half of Whisper White panel.
remove masks and adhere tree with dimentionals or foam strips. add front fence panel also with dimentionals
Stamp Trick or treat and mask it with a post-it, then stamp pumpkins over mask Basic Black on Smoky slate Scrap. stamp tombstones. die cut all pieces, stamp two sets one for each card.
Adhere glitter oval to scallop mat and attach over twine with diementionals -add die cut pumpkins with dimentionals. tuck tombstones in along hill with glue dots.
stamp and adhere inside panel as desired.