Spooktacular Bash Ghoul Friends Gallery
F un card to give a friend around Halloween using Stampin' Up! products.
Cut cardstock and designer paper pieces to the following sizes using a cutting and scoring tool:
- card from Terracotta Tile Cardstock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 3-1/2" x 5-1/2" of framed monster portraits on light gray background design from Monster Bash Designer Series Paper, cut so the portraits are vertical on the vertical paper
- 1" x 5-1/4" of black spider webs on dark gray background design from Monster Bash Designer Series Paper
- 2" x 3-1/2" from Terracotta Tile Cardstock
- 1-1/2" x 4" from Whisper White Cardstock
Adhere the small spider web strip of Monster Bash Designer Paper to the left side of the Terracotta Tile card front so there is about 1/8" of Terracotta Tile showing on the top, bottom, and left edges.
Adhere the large piece of monster portraits Monster Bash Designer Paper to the front of the card so the top and bottom edges are even with the top and bottom edges of the card and there is about 1/8" of Terracotta Tile showing on the right edge.
Mount the "so glad we're such ghoul friends" sentiment from the Spooktacular Bash Set on Block H. Ink it up with the Terracotta Tile Ink Pad. Stamp it in the center of the white strip.
Pick out the long, skinny die with decorative ends from the Ornate Frames Dies. Put it on top of the stamped sentiment on a platform on your cutting and embossing tool so the sentiment is centered. Run through the tool.
Pick out the long, skinny, filigree frame die from the Ornate Frames Dies. Put the die on top of the Terracotta Tile rectangle on a platform on your cutting and embossing tool. Run through the tool. Use the Take Your Pick Die Brush Tip and/or paper-piercing tool on the Take Your Pick to remove the pieces.
Adhere the sentiment cut out to the center of the ornate frame cut out. Then, adhere it to the front of the card so the left edge touches the left edge of the spider web designer paper strip. Play with the placement up and down to decide which portrait you want to cover.
Cut a 4" piece of the Basic Black 3/8" Scalloped Edge Ribbon.
Tie a half knot in the center of the ribbon. Trim the ends.
Use a Mini Glue Dot to adhere the ribbon knot to the lower right corner of the framed sentiment.
Use the mini spatula on the Take Your Pick to carefully peel up a raven shape from the sheet of Monster Bash Enamel Shapes making sure that you get the adhesive backing as well. Adhere it to the card front in the upper left corner of the framed sentiment.