Michele Reynolds
http://inspirationink.typepad.com/inspiration-ink/ michelerey@aol.com |
Spooktacular Bash Creepy Jars Goody Box |
D ecorated Acetate Card Box filled with Halloween treats using Stampin' Up! products.
|
Cut cardstock and designer paper pieces to the following sizes using a Paper Trimmer:
- 4-1/4" x 5-5/8" from Pumpkin Pie Cardstock
- 4- 1/8" x 5-1/2" of spooky ingredient jars on light gray background design from Monster Bash Designer Series Paper, cut so the jars are horizontal on the horizontal rectangle
- 1-3/4" x 2-1/2" from Crushed Curry Cardstock
Fold an Acetate Card Box together, fill it with treats, and close the box.
Adhere the large rectangle of spooky ingredient jars Monster Bash Designer Paper to the Pumpkin Pie rectangle.
Use Tear & Tape Adhesive strips to adhere the matted designer paper to the top of the card box.
Mount the "Have A Spooktacular Halloween" sentiment from the Spooktacular Bash Set on Block C. Ink it up with the Memento Pad. Stamp it in the center of the Crushed Curry rectangle.
Pick out the stitched, tombstone shaped die from the Ornate Frames Dies. Put it on top of the stamped sentiment on a platform on your cutting and embossing tool so the sentiment is centered. Run through the tool.
Use Black Stampin' Dimensionals to adhere the sentiment cut out to the front of the box so it is about 1" from the bottom and right sides.
Use the mini spatula on the Take Your Pick tool to pick up a tombstone shape from a sheet of Monster Bash Enamel Shapes being sure to get the adhesive as well. Adhere it to the front of the box just to the right of the sentiment cut out so the bottoms are level.
Use the mini spatula on the Take Your Pick tool to pick up a large black circle shape from a sheet of Monster Bash Enamel Shapes being sure to get the adhesive as well. Adhere it to the front of the box in the upper left corner between some jars.
Cut an 18" piece of Basic Black 3/8" Scalloped Edge Ribbon.
Wrap the ribbon around the bottom of the box so it covers the bottoms of the sentiment label cut out and the enamel shape. Tie in place with a knot. Trim the ends.