Michele Reynolds
http://inspirationink.typepad.com/inspiration-ink/ michelerey@aol.com |
Spooktacular Bash Books Goody Box |
D ecorated Acetate Card Box filled with Halloween treats using Stampin' Up! products.
|
Cut cardstock and designer paper pieces to the following sizes using a Paper Trimmer and Paper Snips:
- 4-1/4" x 5-5/8" from Basic Gray Cardstock
- 4- 1/8" x 5-1/2" of white filigree on yellow background design from Monster Bash Designer Series Paper
- three books covers cut from books design from Monster Bash Designer Series Paper
- 2-1/4" x 3-1/4" from Terracotta Tile Cardstock
Fold an Acetate Card Box together, fill it with treats, and close the box.
Adhere the large rectangle of white filigree on yellow background Monster Bash Designer Paper to the Basic Gray rectangle.
Use Tear & Tape Adhesive strips to adhere the matted designer paper to the top of the card box.
Mount the "Eat, Drink, & Be Scary" sentiment from the Spooktacular Bash Set on Block B. Ink it up with the Memento Pad. Stamp it near the end of the strip of Terracotta Tile Cardstock in the center. Leave room to punch the sentiment out.
Unlock the 2" Circle Punch. Hold it upside down so you can see the punching area. Slide the stamped sentiment into the punch and get it centered in the punching area so it is in the upper right side of the circle. Punch.
Adhere the sentiment circle punch out to the top of the box in the upper right corner.
If you haven't already done so, cut out three book covers from the books design of Monster Bash Designer Paper using Paper Snips.
Adhere two of the cut out book covers to the front of the box on the left side of the sentiment circle punch out so they overlap the left side of the circle punch out and each other.
Use Black Stampin' Dimensionals to adhere the third book cover cut out to the front of the box so it overlaps the bottom of the sentiment circle punch out and the bottom book on the left.
Use the mini spatula on the Take Your Pick tool to pick up a skull and crossbones shape from a sheet of Monster Bash Enamel Shapes being sure to get the adhesive as well. Adhere it to the front of the box so it overlaps the upper left side of the sentiment circle punch out and the right side of the top book cut out.
Cut a 3" piece of Crushed Curry 3/8" Crinkled Seam Binding Ribbon.
Tie a half knot in the center of the ribbon. Trim the ends.
Use a Mini Glue Dot to adhere the ribbon knot to the top of the box on the lower right side of the sentiment circle punch out.