Barb3275
http://www.BarbsInkPad.com bholicky1@comcast.net |
Moose in the Pines |
|
M ashup using In the Pines and Merry Moose
Cut Crumb Cake CS 5 1/2" x 8 1/2"
Score along 8 1/2" at 4 1/2"
Fold in half for card base.
Card is in landscape position
Cut a piece of Mossy Meadow 4" X 5 1/4"
Emboss with the Evergreen Forest 3D EF.
Using the "snow" stamp from In the Pines and Whisper White craft ink, I randomly stamped snow on this layer.
If you like you can attach to the card base now, I preferred to do it at the end.
Stamp the moose on Crumb Cake CS with Soft Suede ink
Punch out with the moose punch
Put to side
The large tree and the three small trees were stamped using two step stamping.
On Very Vanillas CS with Old Olive ink, stamp the "inside" part of the trees
With Mossy Meadow, stamp the tree outlines over the "inside" of the trees.
Cut out using the pine Woods dies.
Using the smoother edge die from Pine Woods, Cut a piece of the White Felt.
Attach to lower edge of the Mossy Meadow CS and trim to fit
Cut a piece of Very Vanilla CS 3/4" wide and about 2-3"long
Using the Banners Pick a Punch, punch the end of the CS.
Trim this piece to 1 3/4" long.
Stamp the saying from the Merry Moose set using Mossy Meadow ink .
Attach a Gilded Gem
I used dimensionals to attach all pieces to the Mossy Meadow CS.
See card for placement, I did leave a little room under the felt so that the tree trunk of the larger tree could slip under.
On the inside I stamped the Racoon on the log, from Merry Moose, with Soft Suede Ink