Michele Reynolds
http://inspirationink.typepad.com/inspiration-ink/ michelerey@aol.com |
Itty Bitty Greetings Hello Anchor |
M asculine hello card using Stampin' Up! products.
|
|
|
Cut cardstock and designer paper pieces to the following sizes using a Paper Trimmer:
- card from Mossy Meadow Cardstock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" of green map design from Come Sail Away Designer Series Paper
- 1" x 3-1/4" from Sahara Sand Cardstock
Adhere the Come Sail Away Designer Paper to the front of the card.
Pick out the green anchor small card from the Come Sail Away Memories & More Card Pack. Adhere it to the front of the card so it is centered and is vertical on the vertical card.
Mount the single line sentiment of choice from the Itty Bitty Greetings Set on Block G. Ink it up with the Mossy Meadow Ink Pad. Stamp it on one end of the thin strip of Sahara Sand, but leave room to punch it out.
Unlock the Classic Label Punch. Hold it upside down so you can see the punching area. Slide the stamped sentiment into the punch and get it centered in the punching area. Punch.
Adhere the sentiment punch out to the front of the card so it is centered side to side and is centered over the bottom edge of the Memories & More Card.
Pick out an anchor trinket from the Sail Away Trinkets.
Use a Mini Glue Dot to adhere the anchor trinket to the front of the card at a slight angle so it overlaps the right side of the sentiment punch out.
Cut a 3-1/2" piece of the 3/16" Braided Linen Trim.
Tie a half knot in the center of the trim. Fray the ends. Trim the ends.
Use a Mini Glue Dot to adhere the trim knot to the top of the anchor trinket.