Michele Reynolds
http://inspirationink.typepad.com/inspiration-ink/ michelerey@aol.com |
Heartfelt Blooms Tutti-Frutti Flower |
B eautiful card using Stampin' Up! products that can be earned for FREE during Sale-A-Bration 2018.
|
|
Cut cardstock pieces to the following sizes using a Stampin' Trimmer:
- 3-3/4" x 5" from Whisper White Cardstock
- 2" x 4" from Whisper White Cardstock
Pick out one of the Calypso Coral cards from the Tutti-frutti Cards & Envelopes. Fold in half.
Mount the large flower bouquet image from the Heartfelt Blooms Set on Block E. Ink it up with the Calypso Coral Ink Pad. Stamp it in the upper left corner of the large white rectangle so the top and left side go off the edges just a bit and the leaves are pointing to the right. Make sure you have some Grid Paper on your work surface to protect it from ink. Leave the stamp on the block as you will use it again later to stamp on the envelope.
Place the bottom of the stamped white rectangle into the floral patterned folder from the Petal Pair Embossing Folders. Make sure you can see the stamped flower bouquet and you can read the "Sizzix" and "Stampin' Up!" logos on the top of the folder. Place the folder with the card stock inside on top of a Cutting Pad on your Big Shot Platform at the lowest possible setting. Place another Cutting Pad on top of the folder and run through the Big Shot.
Cut a 5" piece of Calypso Coral 3/8" Ribbon from the Shimmer Ribbon Pack.
Lay the ribbon across the stamped and dry embossed white layer near the top of the dry embossing. Flip the cardstock over and fold the ends of the ribbon over. Adhere the ends of the ribbon in place with pieces of Tear & Tape Adhesive.
Remove the protective backing from the Tear & Tape strips and add more SNAIL to the back of the cardstock. Adhere it to the front of the Tutti-frutti card.
Mount the "Thinking of You" sentiment from the Heartfelt Blooms Set on Block B. Ink it up with the Calypso Coral Ink Pad. Stamp in the center of the white strip.
Unlock the Tailored Tag Punch. Holding the punch upside down so you can see the punching area, slide the stamped sentiment into the punch. Center the sentiment in the punching area. Punch.
Use the side of the brush tip of the Calypso Coral Marker to ink up the edges of the punch out.
Use Stampin' Dimensionals to adhere the sentiment punch out to the right side of the card front so it is centered over the ribbon.
Cut a 3-1/2" piece of the Calypso Coral 3/8" Ribbon from the Shimmer Ribbon Pack.
Tie a half knot in the center of the ribbon. Trim the ends.
Use a Mini Glue Dot to adhere the ribbon to the card front on the left side of the sentiment punch out at a slight angle.
Carefully peel up a large glittery circle from a sheet of Glitter & Clear Epoxy Shapes making sure that you get the adhesive backing as well. Adhere it to the large flower on the bouquet near the center as a dew drop.
Pick out one of the Calypso Coral envelopes from the Tutti-frutti Cards & Envelopes.
Re-ink the large flower bouquet image from the Heartfelt Blooms Set with the Calypso Coral Ink Pad. Stamp it in the lower left corner of the front of the envelope. Let the image go off the bottom and left edges. Make sure you have some Grid Paper on your work surface to protect it from ink.