Happy Wishes Tutti-Frutti Flowers

Supplies needed:

Project Recipe:

1. Cut cardstock pieces to the following sizes using a Stampin' Trimmer:
   - 2-3/8" x 3-7/8" from Berry BurstCardstock
   - 2-1/4" x 3-3/4" from Whisper White Cardstock
   - scrap of Whisper White Cardstock at least 1" wide

2. Pick out one of the Lemon Lime Twist cards from the Tutti-frutti Cards & Envelopes. Fold in half.

3. Mount the floral "happy" sentiment from the Happy Wishes Set on Block I. Ink it up with the Berry Burst Ink Pad. Stamp it in the center of the large white rectangle along the bottom.

4. Mount the curved floral spray from the Lots of Lavender Set on Block B. Ink it up with the Lemon Lime Twist Ink Pad. Stamp it on the large white rectangle at a slight angle so it overlaps the "h" in the word "happy" with the curved ends pointing down. Clean the stamp with the Stampin' Mist and Stampin' Scrub, but leave it on the block.

5. Re-ink the curved floral spray image with the Berry Burst Ink Pad. Stamp it on the scrap of white cardstock so you get the center rose image. Leave the stamp on the block as you'll use it again to stamp the envelope.

6. Mount the "be" sentiment from the Happy Wishes Set on Block A. Ink it up with the Flirty Flamingo Ink Pad. Stamp it on the large white rectangle just to the right of the "h" in "happy" and just above the "ap" in "happy."

7. Place the stamped large white rectangle of cardstock on the Stampin' Pierce Mat. Using the mat will help you get a cleaner image each time you stamp.

8. Mount one of the groups of small leaves from the Lots of Lavender Set on Block A. Ink it up with the Lemon Lime Twist Ink Pad. Stamp it over the corresponding set of leaves in the curved floral spray stamped on the large white rectangle.

9. Mount the other group of small leaves from the Lots of Lavender Set on Block A. Ink it up with the Lemon Lime Twist Ink Pad. Stamp it over the other corresponding set of leaves in the curved floral spray stamped on the large white rectangle.

10. Mount the set of two dots (berries or buds) from the Lots of Lavender Set on Block A. Ink it up with the Flirty Flamingo Ink Pad. Stamp it over one of the corresponding sets of berries/buds in the curved floral spray stamped on the large white rectangle. Re-ink the stamp with Flirty Flamingo Ink and stamp over the other set of berries/buds.

11. Mount the solid small rose image from the Lots of Lavender Set on Block A. Ink it up with the Melon Mambo Ink Pad. Stamp it over the corresponding detailed rose image in the center of the curved floral spray stamped on the large white rectangle. Leave the stamp on the block.

12. Place the stamped scrap of white cardstock on the Stampin' Pierce Mat. Using the mat will help you get a cleaner image each time you stamp.

13. Re-ink the solid small rose image from the Lots of Lavender Set with the Melon Mambo Ink Pad. Stamp it over the corresponding detailed rose image on the scrap of white cardstock.

14. Squeeze the lid of the Flirty Flamingo Ink Pad to get a pool of ink in the lid. Open the pad but leave the lid exposed. Use a Blender Pen to pick up some ink from the puddle in the lid and color in some of the round petal flowers on the "happy" sentiment on the large white rectangle. Pick up more ink from the pad lid as needed. Remember to stroke the Blender Pen in one direction only. If you go back and forth, then the card stock could start to pill and tear. Scribble on Grid Paper to clean the tip of the Blender Pen until no more color is coming off.

15. Repeat the step above (making sure you have a clean Blender Pen) using the Melon Mambo Ink Pad to color in some of the lily flowers on the "happy" sentiment stamped on the large white rectangle.

16. Repeat the steps above (making sure you have a clean Blender Pen) using the Fresh Fig Ink Pad to color in some of the rose flowers on the "happy" sentiment stamped on the large white rectangle.

17. Repeat the steps above (making sure you have a clean Blender Pen) using the Lemon Lime Twist Ink Pad to color in some of the leaves and ferns on the "happy" sentiment stamped on the large white rectangle.

18. Adhere the stamped and colored "happy" sentiment to the Berry Burst rectangle.

19. Cut a 5-1/4" piece of Berry Burst 3/8" Metallic-Edge Ribbon so it has an angle on one end.

20. Lay the piece of ribbon along the bottom of the front of the Lemon Lime Twist card so the bottom of the ribbon is about 1-1/8" up from the bottom of the card and the angle is on the left side. Secure the ribbon in place using a small piece of Tear & Tape Adhesive across it.

21. Put some SNAIL on the back of the matted sentiment and remove the protective backing from the Tear & Tape Adhesive on the card front. Adhere the matted sentiment to the card front over the top of the ribbon so the bottom of the matted sentiment is about 1/2" up from the bottom of the card and the right edge is about 1/2" in from the right side of the card.

22. Use Paper Snips to cut out the rose stamped on the scrap of white cardstock.

23. Use a Mini Stampin' Dimensional to adhere the rose cut out to the card front over the rose in the center of the floral spray.

24. Carefully remove one Lemon Lime Twist sequin and one Berry Burst sequin from sheets of Tutti-frutti Adhesive-Backed Sequins making sure you get the adhesive as well as the sequin. Adhere them both to the card front in the upper right corner of the stamped white layer, letting them overlap a bit.

25. Pick out one of the Lemon Lime Twist envelopes from the Tutti-frutti Cards & Envelopes.

26. Re-ink the curved floral spray image with the Berry Burst Ink Pad. Stamp it in the lower left corner on the front of the envelope so the curved ends are pointing upwards.

27. Place the stamped envelope on the Stampin' Pierce Mat. Using the mat will help you get a cleaner image each time you stamp.

28. Mount one of the groups of small leaves from the Lots of Lavender Set on Block A. Ink it up with the Lemon Lime Twist Ink Pad. Stamp it over the corresponding set of leaves in the curved floral spray stamped on the envelope.

29. Mount the other group of small leaves from the Lots of Lavender Set on Block A. Ink it up with the Lemon Lime Twist Ink Pad. Stamp it over the other corresponding set of leaves in the curved floral spray stamped on the envelope.

30. Mount the set of two dots (berries or buds) from the Lots of Lavender Set on Block A. Ink it up with the Flirty Flamingo Ink Pad. Stamp it over one of the corresponding sets of berries/buds in the curved floral spray stamped on the envelope. Re-ink the stamp with Flirty Flamingo Ink and stamp over the other set of berries/buds.

31. Mount the solid small rose image from the Lots of Lavender Set on Block A. Ink it up with the Fresh Fig Ink Pad. Stamp once onto Grid Paper. Without re-inking, stamp it over the corresponding detailed rose image in the center of the curved floral spray stamped on the envelope.