Happy Celebrations Celebrate Stars
B right card perfect for a birthday or other celebration using Stampin' Up! products.
Cut card stock and designer series paper pieces to the following sizes using a Stampin' Trimmer:
- card from Melon Mambo Card Stock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" from Whisper White Card Stock
- 3-7/8" x 5-1/8" from Melon Mambo Card Stock
- 3-1/2" x 3-7/8" of multicolored tiny confetti on white background design from Festive Birthday Designer Series Paper
- 3" x 4-3/4" from Whisper White Card Stock
Mount the group of stars image from the Perpetual Birthday Calendar Photopolymer Stamp Set on Block B. Ink it up with the Melon Mambo Ink Pad. Stamp it in a diagonal pattern from the lower left corner to the upper right corner. Remember to reink the stamp each time.
Adhere the piece of Festive Birthday Designer Series Paper to the center of the stamped Melon Mambo layer.
Cut two pieces of Melon Mambo Thick Baker's Twine each 6" long.
Lay the twine pieces across the card front in the center. Flip the card front over and fold the ends of the twine over. Adhere them in place with pieces of Tear & Tape Adhesive across the ends.
Adhere the Melon Mambo/designer paper layer with twine attached to the large white rectangle and then to the front of the Melon Mambo card.
Pick out one Delicate White Doily. Be careful, they like to stick together!
Lay the doily on your work surface. Ink up a Sponge Brayer by rolling it across the open Melon Mambo Ink Pad. Be sure to roll in one direction only, if you go back and forth, you'll only ink up a small section of the roller. Roll the inked up brayer across the doily until the desired color is achieved. Reink the brayer as needed.
Place the smaller white rectangle on top of the Stampin' Pierce Mat. This will help you get a good impression when stamping with the photopolymer set.
Mount the "celebrate" sentiment from the Happy Celebrations Photopolymer Stamp Set on Block H. Ink it up with the Melon Mambo Ink Pad. Stamp it in the center of the small white rectangle.
Mount the small sentiment of choice from the Happy Celebrations Set on Block G. Ink it up with the Melon Mambo Ink Pad. Stamp it just below the word celebrate on the right side.
Pick out the Lots of Labels Framelits that cuts out a label that is 2-7/8" wide. Place the stamped white card stock on the Cutting Pad on top of the Magnetic Platform on the Big Shot. Place label framelit on top so it is centered over the words. Place another Cutting Pad on top and run through the Big Shot.
Pick out the Celebrations Duo Embossing Folder that says "celebrate." Place the stamped label into the Embossing Folder so the word celebrate will emboss over the stamped celebrate word just slightly off set. Place the folder with the card stock inside on top of a Cutting Pad on your Big Shot Platform at the lowest possible setting. Place another Cutting Pad on top of the folder and run through the Big Shot.
Use the side of the brush tip of the Melon Mambo Marker to outline the label.
Adhere the label to the center of the dyed doily.
Use Stampin' Dimensionals to adhere the label/doily to the center of the card front.
Pick out three Melon Mambo star sequins from the Brights Sequin Assortment. Adhere them to the label as shown using Mini Glue Dots.
Cut an 8" piece of Melon Mambo Thick Baker's Twine. Tie it in a small bow. Trim the ends. Adhere the bow to the left side of the label on top of the twine already on the card using a Mini Glue Dot.