Eden's Garden Strawberry Bunch
H andmade hello card using Stampin' Up! products.
Cut cardstock pieces to the following sizes using a Paper Trimmer:
- card from Melon Mambo Cardstock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" from Just Jade Cardstock
- 3-3/4" x 5" from Basic White Cardstock
- 2" x 3" from Blushing Bride Cardstock
- 2" x 3" from Melon Mambo Cardstock
- 1-1/4" x 3" from Just Jade Cardstock
- 1-1/4" x 2" from Basic White Cardstock
Mount the sentiment of choice from the Eden's Garden Set on an appropriate size block. Ink it up with the Just Jade Ink Pad. Stamp it along the bottom of the horizontal, large white rectangle about 1/2" from the right edge.
Adhere the stamped white rectangle to the center of the large Just Jade rectangle and then to the front of the Melon Mambo card.
Cut a 7" piece of the Just Jade 3/8" Gingham Ribbon from the Flowers For Every Season Ribbon Combo Pack so there is a sharp angle on each end.
Create a loop with the ribbon and lay it on the front of the card at an angle on the left side as shown. Use a tiny piece of Tear & Tape Adhesive across the crossed portion of ribbon to hold it in place. Leave the protective backing in place for now.
Unlock the Strawberry Builder Punch. Hold the punch upside down so you can see the punching area. Slide one end of the Blushing Bride strip into the punch and get it centered in the strawberry punching area. Punch. Repeat with the Melon Mambo strip. Leave the punch unlocked.
Slide one of end of the Just Jade strip into the unlocked Strawberry Builder Punch and get it centered in the leaf cap punching area. Punch. Repeat with the other end of the Just Jade strip so you have two leaf caps.
Slide one of end of the Basic White strip into the unlocked Strawberry Builder Punch and get it centered in the flower punching area. Punch.
Put both strawberry punch outs into the Hammered Metal 3D Embossing Folder. Place the folder with the strawberry punch outs inside on the platform on your Stampin' Cut & Emboss Machine and run through the machine.
Use the Multipurpose Liquid Glue or Fine-Tip Glue Pen to adhere the leaf cap punch outs to the tops of the embossed strawberry punch outs.
Remove the protective backing from the Tear & Tape holding the ribbon in place on the front of the card. Put Stampin' Seal on the back of the Melon Mambo strawberry. Adhere it to the front of the card on the right side of the looped ribbon as shown. Make sure it covers the right side of the Tear & Tape.
Use Stampin' Dimensionals to adhere the Blushing Bride strawberry to the left side of the looped ribbon as shown so it overlaps the other strawberry a bit. Make sure it covers the left side of the Tear & Tape.
Use a Mini Stampin' Dimensional to adhere the small white flower to the front of the card as shown so it overlaps the bottoms of the two strawberries.
Use the mini spatula on the Take Your Pick to carefully peel up an Evening Evergreen jewel from the sheet of 2021-2023 In Color Jewels making sure that you get the adhesive backing as well. Adhere it to the center of the white flower punch out.
Use the mini spatula on the Take Your Pick to carefully peel up a large Magenta Madness gem from the sheet of 2020-2022 In Color Square Gems making sure that you get the adhesive backing as well. Adhere it to the upper right corner of the card so it is a diamond shape.