Dandelion Wishes White Watecolor
Q uick and easy card perfect for lots of occasions using Stampin' Up! products.
Cut cardstock pieces to the following sizes using a Stampin' Trimmer:
- card from Very Vanilla Thick Cardstock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 3-3/4" x 5" from Crumb Cake Cardstock
- 2" x 3" from Very Vanilla Cardstock
Mount the set of three dandelions image from the Dandelion Wishes Set on Block E. Ink it up with the Crumb Cake Ink Pad. Stamp it on the left side of the Crumb Cake rectangle so the top of the dandelions is about 1/4" from the top of the cardstock and the left side of the dandelions is about 1/4" from the left side of the cardstock.
Mount the set of five seeds image from the Dandelion Wishes Set on Block B. Ink it up with the Crumb Cake Ink Pad. Stamp it just to the right of the dandelions near the top.
Use the Whisper White Watecolor Pencil to scribble white all around all the seed heads.
Cut a 5-1/2" piece of Gold 3/8" Metallic-Edge Ribbon.
Lay the ribbon across the stamped Crumb Cake cardstock so the ribbon covers the bottom of the dandelion stems. Flip the layer over and fold the ends of the ribbon over. Adhere the ends of the ribbon in place with pieces of Tear & Tape Adhesive.
Remove the protective backing from the Tear & Tape strips and add SNAIL to the back of the Crumb Cake rectangle. Adhere it to the front of the Very Vanilla Thick card.
Mount either the "wishes for a lifetime..." or the "I made a wish..." sentiment from the Dandelion Wishes Set on Block C. Ink it up with the Crumb Cake Ink Pad. Stamp it in the center of the vanilla rectangle.
Pick out the stitched oval framelit from the Stitched Shapes Framelits that cuts out an oval that is 1-5/16" wide. Place the stamped sentiment on the Cutting Pad on top of the Magnetic Platform on the Big Shot. Place the oval framelit on top so it is centered over the sentiment. Place another Cutting Pad on top and run through the Big Shot.
Use Stampin' Dimensionals to adhere the sentiment oval cut out to the right side of the card so it is centered over the ribbon.
Cut a 3" piece of the Gold 3/8" Metallic-Edge Ribbon.
Slide one end of the ribbon under the ribbon on the card front and tie it in place using a half knot centered under the stems of the dandelions. Trim the ends.
Carefully peel up a medium gem from a sheet of Gold Faceted Gems making sure that you get the adhesive backing as well. Adhere it to the center of the center dandelion.
Carefully peel up 2 small gems from a sheet of Gold Faceted Gems making sure that you get the adhesive backings as well. Adhere them to the centers of the other two dandelions.