Suse Jepson
http://www.suse.stampinup.net stampinsuse@hotmail.com |
Corona Crafting - Launch Party Parcel #3 |
|
Make A6 Card Blank…
Place Magenta Madness A4 card into paper trimmer in landscape format. Cut at 14.8cm, rotate and score at 10.5cm. Fold and burnish score line with bone folder.
Cut the following... (I've used inches as easier for DSP!)
Whisper White : 2 pieces, 1 will be the insert panel. Both 3-1/2 x 5-1/4 inches
DSP : Just Jade Dotty - 2, 1 x 5inch
DSP : Magenta Rose/Poppy pattern, firstly choose which blooms you are going to fussy cut, you need a rose with a poppy and a separate poppy, with foliage.
Also cut a 1x 5 inch strip.
Magenta Madness : 1 x4 inch
Whisper White : 3/4 x 4 inch
Glue the Just Jade DSP strips onto the Whisper White, Left side and Right side. Keep margins equal at side/bottom/top, so when you next glue the centre strip, you'll have neat 'gaps'
Wrap a band of ribbon around the White/DSP strip panel. Secure ends on the back with Tear n Tape.
Glue this panel onto the front of the card blank.
Give your fussy cut blooms a gentle curl with a bone folder.
Apply dimensionals to the back of the large bloom in the middle, now adhere to card front, in the bottom right hand corner, overlapping the Whisper White panel onto the Magenta card blank.
Repeat with the small bloom, and place in the top left corner.
Insert one end of the 3/4inch Whisper White Strip into the desired slot of punch, and punch! KEEP THE WASTE PIECE!!
Colour sentiment stamp with Just Jade Stampin' Write Marker, huff/breathe on the ink, then stamp onto the strip.
Flipover the WASTE piece and lay onto other end of strip, eye up, keeping the sentiment central, draw down the straight edge of the waste piece and then cut along this line in the trimmer to keep it 'square'
Insert the strip into the punch and make your banner.
Repeat with the Magenta Strip, using the sentiment piece to decide how much border your wish to have.
Layer up the 2 banners with glue.
Colour the leaf stamp with the Just Jade marker and stamp the insert panel at bottom right and top left - i tend to stamp off the edge.
Glue in the insert panel.
Stamp the envelope to match.
Add dimensionals to the rear of the layered banner and adhere to card over ribbon band.
Add 2 In-Colour enamel dots at each end of the White banner to decorate.
-x-