Autumn Milk Can 3-D
I was at the Dollar General and came across these milk cans and I knew I just had to have them. I brought them home and took off the sticker that was on them and redecorated it with the Stampin' Up! Country Lane Suite. I love how this turned out.
DSP cut to 3 inches and you will need two of these (the milk can is slightly larger than 12 inches in diameter.)
Adhere the two pieces together.
Wrap around the milk can and cut off any excess.
cut the chicken wire to cover the bottom of the milk can ( you will need 2 1/4 pieces) and adhere it also. I used a sponge and sponged glue on the back here and there then applied it to the can.
cut the copper glimmer paper in 1/2 inch strips (about 2 1/4 inches total is needed) with tear and tape adhere it across the bottom of the dsp covering up the chicken wire edges. See picture.
Add about 48 inches of braided linen thread wrapped around about 3 times and tie into bow. Add clip to top edge of dsp. Color the watering can in Rich Razzelberry, the flowers in Daffodil Delight dark, Pumpkin Pie combo, Leaves in Old Olive combo, berries in Daffodil Delight light and the other round flowers Soft Sea Foam.
Finally add the watering can and flowers with dimensionals. Find some faux autumn flowers (I got mine from the Dollar Tree) and fill the milk can.