T his finished box is using different DSP in the illustrations.
Project Recipe
Card Stock:
DSP Backing Sheet--BOX--10" x 10" scored at 3" on all four sides. NOTE you will need to cut 1" off of each side, then the printed label on the DSP package will be covered with card stock.
Thick Whisper White--LID--6 1/16" x 6 1/16" scored at 1" on each side.
Soft Sea Foam--3 3/4" x 3 3/4" (2); 3 3/4" x 2 3/4" (8); 3 3/4" x 3/4" (4)
Poinsettia Place DSP--3 1/2" x 3 1/2" (2); 3 1/2" x 2 1/2" (4 each of two different designs of DSP); 3 1/2" x 1/2" (4)
Gold Foil-scrap
Red Velvet Paper--6" x 6"
Pear Pizzazz--3" x 3" (3 leaves)
BOX: Burnish all edges well, burnishing folding each direction.
Cut the 4 corners from the DSP Backing Sheet, per illustration.
Die cut the Poinsettia's from Red Velvet Paper using the embossed and the outlined die from the three different sizes, 3 leaves from Pear Pizzazz with the embossed and outlined die, and 3 berry branches from Gold Foil. With Wink of Stella highlight on the poinsettia and leaves. Adhere the 3 different sizes of poinsettia's together with Multipurpose Liquid Glue. Add 3 basic pearls to the center.
Adhere the DSP to the coordinating card stock, per illustration.
LID: Burnish the score lines. Cut down to the horizontal score line, then cut a small wedge off, see illustration.
Adhere the corresponding pieces to the lid, per diagram.
Add mini dimensionals to the back of these pieces. DO NOT ATTACH YET!
BOX: Adhere pieces per illustration (opposite side from the writing).
You will need 2 pieces of 1/4" elastic 8"-9" long.
Measure and mark lightly with a pencil on each of these four flaps. On the 4" side measure across to the middle and mark the at 2", then measure on the 3" side and mark the at 1 1/2".
Using the utility knife make a slit thru all of the layers just wide enough to fit the elastic thru, pulling the elastic thru about 1/2" to 3/4" adhere with hot glue gun. Using the small spatula like end of your Take Your Pick Tool, gently push thru being careful not to break it, give support and the base. Repeat on adjacent side.
Make your slits on the other two sides, thread the elastic thru this slit, then you will need to adjust the tension before using the hot glue gun.
Adhere the decorated Poinsettia to the center of the box bottom, covering the writing.
The tension on the inside of the box should look like the illustration.
Adhere the pieces with the dimensionals to the box, this will cover up where the elastic is glued.
The final step is to turn the box inside out, the elastic will show on all for side and across the bottom. Place the lid onto the bottom box.
This is where the magic begins. Lift the lid off the box and voila, you have a jumping box! Enjoy!