T hank you card made with Stampin' Up! products.
Project Recipe
Cut cardstock and designer paper pieces to the following sizes using a Paper Trimmer:
- card from Just Jade Cardstock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 3-5/8" x 4-1/2" from Cinnamon Cider Cardstock
- 2 pieces each 1-1/2" x 3-1/2" of brick wall design from Bloom Where You're Planted 12" x 12" Designer Series Paper, cut so the bricks are horizontal on the horizontal rectangles
- 1-3/4" x 3-1/2" of white wood wall design from Bloom Where You're Planted 12" x 12" Designer Series Paper, cut so the planks are horizontal on the horizontal rectangle
- 2" x 2-1/2" from Cinnamon Cider Cardstock
- 1-1/2" x 3" from Basic White Cardstock
As you are ready to stamp using the Plentiful Plants Set, place the cardstock or designer paper on the Stampin' Pierce Mat. Using the mat will help you get a cleaner image each time you stamp.
Mount the "you were there & I am very grateful" sentiment from the Plentiful Plants Set on Block H. Use the side of the brush tip of the Garden Green Marker to ink up only the word "grateful." Breathe on the stamp to moisten the ink. Stamp the word "grateful" inside one of the planks on the upper right side of the horizontal white wood wall Bloom Where You're Planted Designer Paper rectangle. Leave about 1/4" between the right edge of the word and the right edge of the designer paper.
Adhere the stamped designer paper rectangle to the center of the large, vertical Cinnamon Cider rectangle leaving a tiny bit of Cinnamon Cider showing on the left and right edges.
Adhere the two rectangles of brick wall Bloom Where You're Planted Designer Paper to the top and bottom of the Cinnamon Cider rectangle leaving a tiny bit of Cinnamon Cider showing around the edges and letting them overlap the top and bottom edges of the white wood wall rectangle.
Adhere the matted and stamped designer paper rectangles to the front of the Just Jade card.
Pick out the notched corners label die from the Tasteful Labels Dies. Put it on top of the small Cinnamon Cider rectangle on a platform on your Stampin' Cut & Emboss Machine. Run through the machine.
Adhere the Cinnamon Cider label cut out to the front of the card so it is centered over the white wood wall rectangle of designer paper and is about 1/4" from the left edge of the designer paper.
Mount the flower pot with handles image from the Plentiful Plants Set on Block B. Ink it up with the Just Jade Ink Pad. Stamp it in the center of the bottom of the vertical white strip.
Mount the spiky plant image from the Plentiful Plants Set on Block B. Ink it up with the Garden Green Ink Pad. Stamp it in the center of the other end of the white strip.
Pick out the matching flower pot with handles die and the matching spiky plant die from the Perfect Plants Dies. Put them on top of the stamped images on a platform on your Stampin' Cut & Emboss Machine so the images are centered in the dies. Make sure the dies do NOT overlap. Run through the machine.
Use Stampin' Dimensionals to adhere the flower pot cut out to the bottom of the label cut out so it is centered side to side.
Use Stampin' Dimensionals to adhere the spiky plant cut out to the center of the label cut out so it is centered and the bottom tucks under the top of the pot cut out.
Cut a 10" piece of the Just Jade & Gold 3/8" Braided Ribbon.
Tie a small bow in the center of the ribbon. Trim the ends.
Use a Mini Glue Dot to adhere the ribbon bow to the front of the card at a slight angle in the bottom right corner of the label cut out.