Project Recipe
Cut large sticky note down to 3-1/4" x 4-1/2".
Tip: be sure to leave as much of the sticky side as possible.
Using the Big Shot and the 4th smallest square from the Layering Squares framelit dies, cut the corner out of the sticky note.
These will be used as masks.
Place the larger mask over the 3-1/4" x 4-1/2" DSP layer and apply Blueberry Bushel ink with a sponge.
Remove the larger mask.
Place the smaller mask over the sponged portion of the DSP.
Cut large sticky note down to 3" wide.
Cut 3/8" strips, stopping each cut before you reach the end of the sticky note.
Place mask over layer pulling every other strip back.
Tip: tape ends down to scrap paper to hold in place where you do not have the sticky side.
Use the Sponge Brayer to apply Real Red ink over surface.
Remove all masks.
Fold 5-1/2" x 8-1/2" Early Espresso cardstock in half for card base.
Adhere 3-7/8" x 5-1/8" DSP to 4" x 5-1/4" Very Vanilla cardstock with SNAIL adhesive. Adhere layers to card front with dimensionals.
Adhere 3-1/4" x 4-1/2" DSP to 3-3/8" x 4-5/8" Early Espresso cardstock with snail adhesive. Adhere layers to card front with dimensionals.
Apply adhesive backed sequins to card front.
Stamp stars from Wood Words stamp set in Blueberry Bushel ink on 4" x 5-1/4" Very Vanilla cardstock.
Stamp sentiment from Wood Words stamp set in Real Red ink.
Stamp sentiment from At Home With You stamp set in Early Espresso ink.
Adhere layer to inside of card with SNAIL adhesive.
Hope you enjoy!