P layful hello card using Stampin' Up! products.
Cut cardstock and glimmer paper pieces to the following sizes using a Paper Trimmer:
- card from Orchid Oasis Cardstock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" from Basic White Cardstock
- 3/4" x 5-1/4" of darker gradient Orchid Oasis glimmer paper from 2022-2024 In Color 6" x 6" Glimmer Paper
- 1" x 3" from Orchid Oasis Cardstock
Place the white rectangle on the Simply Scored Scoring Tool so it is in the upper left corner of the tool and is vertical. Use the stylus to score all the way down the cardstock at the 1", 1-1/8", and 1-1/4" marks.
Mount the robot with flower image from the Nuts & Bolts Set on Block D. Ink it up with the Orchid Oasis Ink Pad. Stamp it in the bottom right corner of the scored, vertical white rectangle so it is about 3/8' from the right edge and about 3/4" from the bottom edge.
Mount the shadow image from the Nuts & Bolts Set on Block G. Ink it up with the Orchid Oasis Ink Pad. Stamp it just below the stamped robot on the white rectangle.
Adhere the strip of Orchid Oasis Glimmer Paper to the left edge of the vertical white rectangle so that the top, bottom, and left edges are even.
Cut a 12" piece of the Orchid Oasis Baker's Twine from the 2022-2024 In Color Baker's Twine Pack.
Fold the twine in half.
Lay the folded twine across the stamped and scored cardstock/glimmer paper rectangle so it covers the seam between the cardstock and glimmer paper. Fold the ends of the folded twine over and secure the twine in place on the back of the rectangle using strips of Tear & Tape Adhesive.
Remove the protective backings from the Tear & Tape pieces and add Stampin' Seal to the back of the white rectangle. Adhere it to the front of the Orchid Oasis card.
Cut an 18" piece of the Orchid Oasis twine from the 2022-2024 In Color Baker's Twine Pack.
Fold the twine in half. Slide one end of the folded twine under the twine already on the card front near the top. Tie in place with a small bow. Trim the ends.
Mount the "Greetings, Kind Human" sentiment from the Nuts & Bolts Set on Block H. Ink it up with the Orchid Oasis Ink Pad. Stamp it in the center of the Orchid Oasis strip.
Use Paper Snips Scissors to cut out the words "Greetings" and "Human" by hand.
Use Mini Stampin' Dimensionals to adhere the word cut outs to the front of the card as shown at slight angles just above the robot's head and just to the right of the scored lines.
Use the mini spatula on the Take Your Pick to carefully peel up a large Orchid Oasis flower from the sheet of Fun Flowers Resin Shapes. Adhere it to the center of the flower the robot is holding.